Whirlpool 2DWTW4705EW1 사용 및 관리 매뉴얼 - 페이지 9
{카테고리_이름} Whirlpool 2DWTW4705EW1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 2DWTW4705EW1 17 페이지. Top-loading washer
페이지 인쇄7�
Select LOAD SIZE
Select the load size setting most suitable for your load. Small
will add a low amount of water for smaller loads and Ex Large
will add the greatest amount of water for large or bulky loads.
Items need to move freely.
8�
Select WASH TEMP
Once you select a cycle, select the desired wash temperature
by turning the Wash Temp knob to the appropriate setting
based on your load. All rinses are tap cold.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Temp
Hot
Some cold water is added to save
energy. This will be cooler than your
hot water heater setting.
Warm
Some cold water will be added, so
this will be cooler than what your
previous washer provided.
Cool
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Cold
This is the temperature from your
faucet. If your tap cold water is very
cold, warm water may be added
to assist in soil removal and help
dissolve detergent.
Suggested Fabrics
Whites and pastels
Durable garments
Heavy soils
Bright colors
Moderate to light soils
Colors that bleed or fade
Light soils
Dark colors that bleed
or fade
Light soils
9�
Select SOIL LEVEL
(on some models)
Select the soil level by turning the Soil Level knob to the
desired setting.
10�
Select EXTRA RINSE, if desired
If you would like to add an extra rinse to any cycle, turn the
knob to desired setting.
11�
Press START/STOP to begin
wash cycle
Press START/STOP to start the wash cycle. When the cycle
has finished, the Done/Cycle Complete indicator will light.
Promptly remove garments after cycle has completed to avoid
odor, reduce wrinkling, and rusting of metal hooks, zippers,
and snaps.
Unlocking the Lid to Add Garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/STOP; the lid will unlock once the washer
movement has stopped. This may take several minutes
if the load was spinning at high speed. Then close lid and
press START/STOP again to restart the cycle.
If lid is left open for more than 10 minutes, the water will
pump out automatically.
9