Whirlpool 3354199 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Whirlpool 3354199에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3354199 8 페이지.
페이지 인쇄Before you start.. .
Check location where washer will
be installed. Proper installation is
your responsibility Make sure you
have everything necessary for
correct installation,
Protection from weather:
do not
store or operate washer below 32°F
Coin-operated
washers are equipped
with a meter case, console, timer,
selector switches and indicator lights.
The coin slide mechanism, slide
mounting bolt, slide extension, service
door panel lock and key, top lock
and key, coin vault, and coin vault
lock and key are not included with this
washer and are needed to complete
installation. These items are available
from usual industry sources.
Grounded
electrical
outlet:
is required. See Electrical
requirements.
Single washer installations require
I
Hot and cold water faucets:
must be within 4 feet of the
back of the washer and provide
water pressure IO-100 PSI.
A pressure reduction valve
should be used in the supply line
where inlet pressure entering the
building exceeds 100 PSI to prevent
damage
to the washer
mixing valve.
V'minimum
risers to provide an
air cushion and prevent noise and
Untape and open
damage
to valves.
washer lid. Remove
packages
and hoses
fron 7 washer.
\I
/
On coin-operated
washers, front
access to the pump area is
available
by removing the two No. 10
Tot-x screws and then removing the
front panel. Non-coin operated
washers do not have a removable
front panel. The cabinet and top
assembly must be removed by
removing clips under console on
the non-coin operated
washer.
r heater: set to deliver
"F water to the washer.
9
level floor: maximurr
washer 1 inch.
I slope under
Staidpipe
drain system: needs
a two-inch minimum diameter
standpipe
with minimum
carry-away
capacity
of 17 gallons
per minute. Top of standpipe
must
Non-coin operated washers are
equipped
with a console, push to start
timer, selector switches and indicator
lights. (not pictured]
be at least 34 inches high and no
higher than 72 inches from bottom
of washer.
Support: floor must be sturdy enough to
support loaded washer weight 315 pounds.
A floor drain should be provided
under the bulkhead. Prefabricated
bulkheads with electrical outlets,
water supply lines and drain facilities
should be used only where local
codes permit.
Important:
Observe all governing
codes and ordinances.
.14o"F
PAGE1