Whirlpool 3360619 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Whirlpool 3360619에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3360619 17 페이지. Commercial electronic washer 120-volt, 60-hz models
페이지 인쇄Tools needed for
installation:
level
wrench
flat-blade
screwdriver
utility
scissors
knife
Parts supplied for
installation:
Remove parts from packages. Check
that all parts were included.
1 hose clamp
2 inlet hoses
4 flat water hose washers
2 front-leveling legs with nuts
1 drain hose
PAGE 3
Electrical requirements
pliers
Electrical Shock Hazard
Plug into a grounded 3-prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
If codes permit and a separate ground
wire is used, it is recommended that a
qualified electrician determine that
the ground path is adequate.
Do Not ground to a gas pipe.
Check with a qualified electrician if
you are not sure the washer is properly
grounded.
Do Not have a fuse in the neutral or
ground circuit.
A 120-volt, 60-Hz, AC-only, 15- or
20-ampere fused electrical supply is
required. (Time-delay fuse or circuit
breaker is recommended.) It is
recommended that a separate circuit
serving only this appliance be provided.
Recommended
ground method
For your personal safety, this appliance
must be grounded. This appliance is
equipped with a power supply cord
having 3-prong ground plug. To
minimize possible shock hazard, the
cord must be plugged into a mating
3-prong ground-type outlet, grounded
in accordance with local codes and
ordinances. See Figure 1. If a mating
outlet is not available, it is the personal
responsibility and obligation of the
customer to have a properly grounded
3-prong outlet installed by a qualified
electrician.
WARNING – Improper connection of
the equipment-grounding conductor
can result in a risk of electric shock.
Check with a qualified electrician or
serviceman if you are in doubt as to
whether the appliance is properly
grounded. Do not modify the plug
provided with the appliance – if it will
not fit the outlet, have a proper outlet
installed by a qualified electrician.
WARNING
3-prong ground-
3-prong
type outlet
ground
plug
ground
prong
power supply
cord
Figure 1
Now start...
With washer in laundry area.
WARNING
Excessive Weight Hazard
Use two or more people to move
and install washer.
Failure to do so can result in back
or other injury.
Pull the strap completely
out of the washer.
1.
Remove tape that covers
shipping strap. Pull to
completely remove the shipping
strap with 2 cotterpins from the inside
of the washer.
Pull firmly to remove the
end of shipping strap from
the back of the washer. The shipping
strap plug must be completely
removed from the washer for the
self-leveling legs to be released.
Save the shipping strap for use in
Step 6.
shipping
tape