Whirlpool 3LSR6233EQ1 사용 및 관리 매뉴얼 - 페이지 14
{카테고리_이름} Whirlpool 3LSR6233EQ1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LSR6233EQ1 39 페이지.
페이지 인쇄
CARING FOR YOUR WASHER
W
INTER STORAGE
Install and store your washer where it will not
freeze. Because some water may stay in the
hoses, freezing can damage your washer. If storing
or moving your washer during freezing weather,
winterize it.
To winterize washer:
1.
Shut off both water faucets.
2.
Disconnect and drain water inlet hoses.
3.
Put 1 L (1 quart) of R.V.-type antifreeze in the
basket.
4.
Run washer on a drain and spin setting (see
"Rinse/Drain and Spin") for about 30 seconds
to mix the antifreeze and water.
5.
Unplug the power supply cord.
I
NLET HOSES
Replace inlet hoses after 5 years of use to reduce
the risk of hose failure. Inspect and replace inlet
hoses if bulges, kinks, cuts, wear, or leaks
are found.
14
,
,
MOVING
VACATION CARE
To use washer again:
1.
Flush water pipes and hoses.
2.
Reconnect water inlet hoses.
3.
Turn on both water faucets.
4.
Reconnect power supply cord.
5.
Run the washer through a complete cycle with
250 mL (1 cup) of detergent to clean out
antifreeze.
Non-use or vacation care:
Operate your washer only when you are at home. If
you will be on vacation or not using your washer for
an extended period of time, you should:
•
Unplug the power supply cord or turn off electrical
power to the washer.
•
Turn off the water supply to the washer. This helps
avoid accidental flooding (due to a water pressure
surge) while you are away.
When replacing your inlet hoses, mark the date of
replacement on the label with a permanent marker.