Whirlpool 3XLBR5432 사용 및 관리 매뉴얼 - 페이지 11
{카테고리_이름} Whirlpool 3XLBR5432에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3XLBR5432 13 페이지. Two speed automatic washer
Whirlpool 3XLBR5432에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (35 페이지), 설치 지침 매뉴얼 (11 페이지), 사용 및 관리 매뉴얼 (40 페이지)
페이지 인쇄
Ag.ator o peration
,,,,
,
,,,,
Is there excessive sudsing?
Always measure detergent. Follow manufacturer's
directions.
If you have very soft water, you might need to use less
detergent.
Is your voltage low?
Check your electrical source or call an electrician. Do not use
an extension cord.
Washer continues to fill or drain, or the cycle seems stuck
Is the top of drain hose lower than the water level in
washer?
The top of the hose must be higher than the water level in the
washer for proper operation. See the Installation Instructions.
Does the drain hose fit too tightly in the standpipe, or is it
taped to the standpipe?
The drain hose should be loose yet fit securely. Do not seal
the drain hose with tape. The hose needs an air gap. See the
Installation Instructions.
Washer makes noise
•
Is the load balanced and the washer level?
The wash load should be balanced and not overloaded.
The washer must be level. The front feet should be properly
installed and the nuts tightened. Reset the rear leveling legs
(if needed). See the Installation
Instructions.
Did you completely remove the yellow shipping strap with
cotter pins?
See the Installation Instructions.
Are the gears engaging after the drain and before spin, or
is the upper part of agitator clicking during wash?
These are normal washer noises.
Washer leaks
Check the following:
Are the fill hoses tight? Are the fill hose washers properly
seated? Is the drain hose clamp properly installed? See the
Installation Instructions.
•
is the sink or drain clogged?
Sink and standpipe must be able to handle 17 gallons (64 L)
of water per minute.
•
Is water deflecting off the tub ring or the load?
Center the tub before starting the washer.
The wash load should be balanced and not overloaded. The
fill or spray rinses can deflect off the load.
The washer must be level. The front feet should be properly
installed and the nuts tightened. Reset the rear leveling legs
(if needed). See the Installation instructions.
•
Check household plumbing for leaks.
Washer basket is crooked
=
Was the washer basket pulled forward during loading?
The wash load should be balanced and not overloaded. Push
the basket to the center before starting wash.
•
Is the load balanced and the washer level?
The wash toad should be balanced and not overloaded.
The washer must be level The front feet shoutd be properly
installed and the nuts tightened. Reset the rear reveling legs
(if needed). See the installation Instructions.
•
The washer basket moves while washing.
This is normal.
•
The top of the agitator is
loose,
or
moves in only one
direction.
This is normal.
Dispensers clogged or bleach leaking
•
Did you follow the manufacturer's
directions when adding
detergent and fabric
softener to the dispensers?
Measure detergent and fabric softener. Carefully pour into the
dispensers. Wipe up all spills.
Dilute fabric softener in the fabric softener dispenser.
Did you put powdered or color-safe bleach in the liquid
chlorine bleach dispenser?
Add powdered or liquid color-safe bleach directty to the
basket. Do not use the chlorine bleach dispenser for color-
safe bisash.
Load too wet
•
Did you use the fight cycle for the load being washed?
Select a cycle with a higher spin speed (if available).
•
Did you use a cold rinse?
Cold rinses leave toads wetter than warm rinses. This is
normal.
Residue or lint on load
•
Did you sort properly?
Sort lint givers (towels, chenille) from lint takers (corduroy,
synthetics). Also sort by color.
•
Did you overload the washer?
The wash load must be balanced and not overloaded. Lint
can be trapped in the load if overloaded. Wash smaller loads.
•
Check the following:
Was paper or tissue left in the pockets?
Did you use enough detergent? Follow manufacturer's
directions.
Use enough detergent to hold the lint in the water.
Is your water colder than 7O°F (21 °C)? Wash water colder
than 7O°F (21°C) may not completely
dissolve the detergent.
Stains on load
Did you follow the manufacturer's
directions when adding
detergent and fabric softener?
Measure detergent and fabric softener. Use enough detergent
to remove soil and hold it in suspension.
Dilute fabric softener and add to the rinse portion of a cycle
only. Do not drip fabric softener on clothes.
•
Is there above average iron (rust) in water?
You may need to install an iron filter.
•
Did you properly sort the load?
Sort dark clothes from whites and lights.
•
Did you unload the washer promptly?
To avoid dye transfer, unload the washer as soon as it stops.
11