Whirlpool 4GATW4900 설치 지침 매뉴얼 - 페이지 5
{카테고리_이름} Whirlpool 4GATW4900에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4GATW4900 27 페이지.
Whirlpool 4GATW4900에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (27 페이지)
![Whirlpool 4GATW4900 설치 지침 매뉴얼](/uploads/products/server2/6792041/6792041.png)
INSTALLATION INSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install washer.
Failure to do so can result in back or other injury.
Before you start: remove shipping materials
It is necessary to remove all shipping materials for proper
operation and to avoid excessive noise from washer.
1.
Move washer
Move washer to within 4 ft (1.2 m) of its final location; it must
be in a fully upright position.
NOTE: To avoid floor damage, set washer onto cardboard
before moving it and make sure lid is taped shut.
2.
Remove
shipping
base
Remove
packing
tray from tub
Remove tape from washer lid, open lid and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Keep tray in case you need to move washer later.
f4.
Free power cord
Firmly grasp power cord plug and pull to free from rear panel.
Gently place power cord over console to allow free access
to back of washer.
To avoid damaging floor, place cardboard supports from
shipping carton on floor behind washer. Tip washer back and
place on cardboard supports. Remove shipping base. Set
washer upright.
IMPORTANT:
Removing shipping base is necessary for proper
operation. If your washer includes a sound shield, please refer
to the instructions
included with the sound shield to install it at
this time.