Whirlpool 4GNTW4600 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool 4GNTW4600에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4GNTW4600 44 페이지. Top-loading washer
Whirlpool 4GNTW4600에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (27 페이지)

페이지 인쇄

WASHER

MAINTENANCE

WATER iNLET HOSES

Replace inlet hoses after 5 years of use to reduce the risk of

hose failure. Periodically inspect and replace inlet hoses if

bulges, kinks, cuts, wear, or leaks are found.

When replacing your inlet hoses, mark the date of replacement

on the label with a permanent marker.

WASHER

CARE

Recommendations

to Help Keep Your Washer

Clean

and Performing

at its Best

1. Always follow the detergent manufacturer's

instructions

regarding the amount of detergent to use. Never use

more than the recommended

amount because that may

increase the rate at which detergent and soil residue

accumulate

inside your washer, which in turn may result

in undesirable odor.

2. Use warm and hot wash water settings sometimes (not

exclusively cold water washes), because they do a better

job of controlling

the rate at which soils and detergent

accumulate.

3. Always leave the washer lid open between uses to help

dry out the washer and prevent the buildup of odor-

causing residue.

Cleaning

Your Top Loading

Washer

Read these instructions

completely before beginning the

routine cleaning processes recommended

below. This

Washer Maintenance Procedure should be performed,

at a minimum, once per month or every 30 wash cycles,

whichever occurs sooner, to control the rate at which soils

and detergent may otherwise accumulate in your washer.

Cleaning

the inside of the Washer

To keep your washer odor-free, follow the usage instructions

provided above, and use this recommended

monthly

cleaning procedure:

Recommended

Cycle for Cleaning

the Washer

Refer to the "Cycle Guide" for the optimal cycle for cleaning

the inside of the washer. Use this cycle with liquid chlorine

bleach as described below.

Begin procedure

1. Chlorine

Bleach Procedure:

ao Open the washer lid and remove any clothing

or items.

b. Add 236 mL (1 cup) of liquid chlorine bleach

to the bleach compartment.

NOTE: Use of more liquid chlorine bleach than is

recommended

above could cause washer damage

over time.

co Close the washer lid.

d. Do not add any detergent or other chemical

to the washer when following this procedure.

eo Select the cycle recommended

for cleaning the

inside of the washer.

fo Press the START/Pause/Unlock

Lid button to start

the cycle.

NOTE: For best results, do not interrupt cycle. If cycle

must be interrupted,

press START/Pause/Unlock

Lid

once or twice (depending on model). After the cycle has

stopped, run a RINSE / SPIN cycle to rinse cleaner from

washer.

WASHER

CARE (cont.)

Cleaning

the Dispensers

After a period of using your washer, you may find some

residue buildup in the washer's dispensers. To remove

residue from the dispensers, wipe them with a damp cloth

and towel dry. Do not attempt to remove the dispensers or

trim for cleaning. The dispensers and trim are not removable.

If your model has a dispenser drawer, however, remove the

drawer and clean it before or after you run the Clean Washer

cycle. Use an all-purpose

surface cleaner, if needed.

Cleaning

the Outside

of the Washer

Use a soft, damp cloth or sponge to wipe away any spills.

Use only mild soaps or cleaners when cleaning external

washer surfaces.

iMPORTANT: To avoid damaging the washer's finish, do not

use abrasive products.

NON=USE AND VACATION

CARE

Operate your washer only when you are home. If moving, or

not using your washer for a period of time, follow these steps:

1. Unplug or disconnect

power to washer.

2. Turn off water supply to washer, to avoid flooding due

to water pressure surge.

WINTER

STORAGE

CARE

iMPORTANT: To avoid damage, install and store washer

where it will not freeze. Because some water may stay in

hoses, freezing can damage washer. If storing or moving

during freezing weather, winterize your washer.

To winterize

washer:

1. Shut off both water faucets; disconnect

and drain water

inlet hoses.

2. Put 1 L (1 qt.) of R.V.-type antifreeze in basket and run

washer on RINSE/SPIN cycle for about 30 seconds

to mix antifreeze and remaining water.

3. Unplug washer or disconnect

power.