Whirlpool 4GWTW4740 사용 및 관리 매뉴얼 - 페이지 5
{카테고리_이름} Whirlpool 4GWTW4740에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4GWTW4740 47 페이지.
Whirlpool 4GWTW4740에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (27 페이지), 설치 지침 매뉴얼 (27 페이지)
페이지 인쇄
O
START/PAUSE/UNLOCK
BUTTON
Press to start the selected cycle; press again
to pause the cycle and unlock the lid.
NOTE: if the washer is spinning, it
may take several minutes to unlock the
lid. Press and hold for 3 seconds to
cancel a cycle.
START
Pause/Unlock
CYCLE
STATUS
LIGHTS
iNDiCATOR
Cyde Status
Fill
Wash
Rinse
Spin
Done
Lid LOCked
The Cycle Status Lights shows the progress of a cycle.
At each stage of the process, you may notice sounds or
pauses that are different from traditional washers.
SENSING/FILL
(varies by model)
When the START/Pause/Unlock
button is pressed, the
washer will fill to the selected water level. If the lid is
closed when the machine is done filling, the lid will lock
and the machine will begin operation.
If the lid is open when the water stops entering the
machine, the cycle will not begin until the lid has been
closed and the START/Pause/Unlock
button is pressed.
If the cycle has not been started within 10 minutes of
the water filling the washer, the washer will pump out the
water.
NOTE: Avoid opening lid during sensing phase.
The sensing process will start over when the washer is
restarted. The sensing light may also come on during the
Soak and Wash portions of the cycle. This is normal.
To restart the washer after the lid has been opened,
press Start.
WAS N
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as
the washer rinses and moves the load. et d6place
la charge. You may hear the motor turning on briefly
(short hum) to move the basket while filling. Fabric
softener will be added if the Fabric Softener option
was selected.
Some cycles use spray rinsing. After draining and
spinning out wash water, the washer will continue to
spin and spray in rinse water for the entire rinse time.
SPIN
The washer spins the load at increasing speeds for
proper water removal, based on the selected cycle
and spin speed.
DONE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
To allow for proper spin operation, the
lid will lock and the Lid Lock light will
turn on. This light indicates that the lid
is locked and cannot be opened.
If you need to open the lid, press
START/Pause/Unlock.
The lid will
unlock once the washer movement
has stopped. This may take several
minutes if the load was spinning at
high speed. Press START/Pause/
Unlock again to resume the cycle.
CZ)
Lid
Locked
START
Pause/Unlock
_ ca_cal