Whirlpool 6400 사용 설명서 지침 - 페이지 14

{카테고리_이름} Whirlpool 6400에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 6400 16 페이지. 6kg, 1400rpm, washing machine with supereco programme, white, wwdc 6400

페이지 인쇄

Failure indication

lights up

"Service"

If your washing machine has no time display, check which of the previously described

situations could be the origin of the fault and follow the corresponding instructions.

Indication on display

(if available)

"bdd"

(in case your washing

machine has no

display: all lamps of the

programme sequence

indicator light up)

from "F02" to "F35"

(except "F09")

"F09"

"FA"

"Fod"

Description - Causes - Solutions

Appliance stops during the programme.

"Drum flaps open" (the drum flaps have not been

closed properly).

Push the "Reset"

and wait until the "Door open"

Open lid and close drum flaps, then select and start

desired programme again. If fault persists, notify our

After-Sales Service.

"Electrical module fault"

Select and start "Drain" programme or push

"Reset" button

"Water level too high" (after programme

cancellation or false operating). Switch off appliance

and then switch it on again, select programme

"Drain" and start within 15 sec.

"Waterstop fault"

Switch off appliance, pull out mains plug and turn

water tap off. Tilt appliance forward carefully to

allow collected water to flow out from the bottom.

Then:

• Plug in the appliance again.

• Turn the water tap on (if water immediately flows

into the appliance without the appliance being

started, there is a failure; turn off the tap and

notify After-Sales Service).

• Select and start the desired programme again.

"Overfoaming"

Too much foam interrupted the wash programme.

• Select and start "Rinse & Spin" programme

• Afterwards select and start desired programme

again, using less detergent.

If faults persist, unplug the appliance, turn off the

water tap and contact our After-Sales Service (see

next chapter).

GB 14

button for at least 3 seconds

lights up.

for at least 3 seconds.