Ariston PH 760 RF GH 사용자 설명서 - 페이지 2

{카테고리_이름} Ariston PH 760 RF GH에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston PH 760 RF GH 11 페이지. Ariston hob

페이지 인쇄

The position of the corresponding gas burner or electric

hot plate (if present) is indicated on each control knob.

Gas Burners

The burners differ in size and power. Choose the most

appropriate one for the diameter of the cookware being

used.

The burner can be regulated with the corresonding control

knob by using one of the following settings:

•

Off

High

Low

To light the selected burner, first press the

corresponding knob down fully, turn it anti-clockwise

to the high flame symbol, and keep the knob pressed

down until the burner ignites for approximately 2-3

seconds to allow the safety device "F", which keeps the

flame lit automatically, to heat up.

To turn on one of the burners, place a lighted match or

lighter near the burner, press the knob all the way in and

turn it anti-clockwise to the "High" setting.

To turn off a burner, turn the knob clockwise until it stops

(it should be on the "•" setting).

Caution: If the burner accidently goes out, turn off the

gas on the control knob and wait at least 1 minute before

you try to to light it again.

The "separate double flame" burner

This burner consists of two concentric burners which can

operate either together or separately.

Use of the double flame on the maximum setting gives a

very high power which reduces cooking times with respect

to conventional burners.

Moreover the double flame crown provides a more uniform

distribution of heat on the bottom of the pan, when using

both burners on minimum.

Pots and pans of all sizes can be used. In the case of the

smaller pots and pans we recommend the use of only the

internal burner.

There is a separate control knob for each of the "separate

double flame" burners.

The knob marked by the symbol

burner;

The knob marked by the symbol

burner.

To turn on one of the rings, press the relative knob in all the

way and turn it anti-clockwise to the high setting

is fitted with an electronic igniter that automatically starts when

the knob is pressed in.

How To Use Your Appliance

operates the external

operates the internal

. The burner

Since the burner is equipped with a safety device "F",

after lighting the burner keep the knob pressed in for

about 2-3 seconds to allow the device which keeps the

flame lit automatically to heat up.

The selected burner can be regulated using the corresponding

knob, as follows:

•

Off

High

Low

To turn off a burner, turn the knob clockwise until it stops

(it should be on the "•" setting).

Ceramic Glass Module (only on certain models)

This cooktop is fitted with dual-ring radiant heating elements

located beneath the glass. It is possible to turn on only the

circular part of the elemement (identified by the letter "A") or

the cooking surface can be enlarged by turning on both "A"

and "B". To turn only the circular "A" element, simply turn the

knob in the clockwise direction to any one of the 12 available

settings. To add the "B" section, turn the knob to setting 12

and then click it into the

the knob in the counter-clockwise direction to one of the 12

settings.

The figure shows the heating zones, which become red when

the element is turned on.

A. Circular heating zone;

B. Extended heating zone;

C. Indicator light to show when the cooking zone is above

60°C, even after the heating element has been turned

off.

When the knob is on any of the settings other than "Off",

the "H" operating light comes on.

setting. Then proceed by turning