Whirlpool 7MWTW1700EM1 사용 및 관리 매뉴얼 - 페이지 19

{카테고리_이름} Whirlpool 7MWTW1700EM1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWTW1700EM1 32 페이지. Top-loading washer

페이지 인쇄

Control Panel and Features

TAMAÑO DE CARGA (Load Size)

Select the setting most suitable for your load. CH (Small)

will add a low amount of water for smaller loads and EG

(Extra Large) will add the most amount of water for large

or bulky loads. Items need to move freely. Tightly packing

can lead to poor cleaning performance and may increase

wrinkling and tangling.

TEMPERATURA (Temperature)

the washer senses and maintains uniform water

temperatures by regulating incoming hot and cold water.

Select a wash temperature based on the type of fabric

and soils being washed. For best results and following

the garment label instructions, use the warmest wash

water safe for your fabric.

• On some models and cycles, warm and hot water may

be cooler than your previous washer.

• Even in a cold and cool water wash, some warm water

may be added to the washer to maintain a minimum

temperature.

ENJUAGUE ADICIONAL (Extra Rinse)

This option can be used to automatically add a second rinse

to most cycles.

WASH CYCLE KNOB

Use the Wash Cycle knob to select cycles on your washer.

Knob does not advance during the progress of the cycle, see

cycle status/progress lights for each stage of the process.

See "Cycle Guide" for detailed descriptions of cycles.

INICIO/PAUSA (Start/Pause) Button

Press to start the selected cycle; press again to pause the

cycle and unlock the lid. Press and hold for 3 seconds

to cancel a cycle.

NOTE: If the washer is spinning, it may take several

minutes to unlock the lid.

TAPA (Lid Locked)

To allow for higher spin speeds, the lid will

lock and the Tapa (Lid Locked) light will turn

on. When this light is lit, the lid is locked

and cannot be opened. When this light is

blinking, the washer is paused. When this

light is off, the lid can be opened.

If you need to open the lid, press

INICIO/PAUSA (Start/Pause). The lid will

unlock once the washer movement has

stopped. This may take several minutes

if the load was spinning at high speed.

Press INICIO/PAUSA again to resume the cycle.

ETAPAS DE LAVADO (Cycle Status Indicator)

The Cycle Status Lights show the progress of a cycle.

At each stage of the process, you may notice sounds or

pauses that are different from traditional washers.

LLENANDO (Sensing Fill)

When the Inicio/Pausa (Start/Pause) button is pressed,

the washer will fill to the selected water level. If the lid is

closed when the washer is done filling, the washer will

begin operation.

If the lid is opened or the Inicio/Pausa button is pressed,

the cycle will pause. Closing the lid and/or pressing the

Start/Pause button will resume the cycle. If the cycle

remains paused with the lid open for 10 minutes, the

washer will pump out the water.

NOTE: The lid will remain unlocked throughout the wash

cycle, then lock before the first spin cycle begins.

LAVADO (Wash)

You will hear the agitator moving the load. The motor

sounds may change at different stages in the cycle.

The wash time is determined by the selected soil level.

ENJUAGUE (Rinse)

You will hear sounds similar to the wash cycle as the

washer rinses and moves the load. You may hear the

motor turning on briefly (short hum) to move the basket

while filling.

Some cycles use spray rinsing. After draining and

spinning out wash water, the washer will continue to spin

and spray in rinse water for the entire rinse time.

DRENADO/EXPRIMIDO (Drain/Spin)

The washer spins the load at increasing speeds for

proper water removal, based on the selected cycle and

spin speed.

LISTO (Done)

Once the cycle is complete, this light will come on.

Remove the load promptly for best results.