Whirlpool 7MWTW1700EM1 사용 및 관리 매뉴얼 - 페이지 24
{카테고리_이름} Whirlpool 7MWTW1700EM1에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWTW1700EM1 32 페이지. Top-loading washer
Washer Maintenance
WATER INLET HOSES
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges,
kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement on
the label with a permanent marker.
WASHER CARE
Recommendations to Help Keep Your Washer Clean
and Performing at its Best
1� Always follow the detergent manufacturer's instructions
regarding the amount of detergent to use. Never use more
than the recommended amount because that may increase
the rate at which detergent and soil residue accumulate
inside your washer, which in turn may result
in undesirable odor.
2� Use warm and hot wash water settings sometimes (not
exclusively cold water washes), because they do a better
job of controlling the rate at which soils and detergent
accumulate.
3� Always leave the washer lid open between uses to
help dry out the washer and prevent the buildup of
odor-causing residue.
Cleaning Your Top Loading Washer
Read these instructions completely before beginning the
routine cleaning processes recommended below. This Washer
Maintenance Procedure should be performed, at a minimum,
once per month or every 30 wash cycles, whichever occurs
sooner, to control the rate at which soils and detergent may
otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions
provided above, and use this recommended monthly cleaning
procedure:
Recommended Cycle for Cleaning the Washer
Refer to the "Cycle Guide" for the optimal cycle for cleaning
the inside of the washer. Use this cycle with washer cleaner
or liquid chlorine bleach as described below.
Begin procedure
1� Washer Cleaner Cycle Procedure (Recommended for
Best Performance):
a� Open the washer lid and remove any clothing or items.
b� Place a washer cleaner tablet in the bottom of the
washer basket.
c� Do not place a washer cleaner tablet in the detergent
dispenser.
d� Do not add any detergent or other chemical to the
washer when following this procedure.
e� Close the washer lid.
f� Select the cycle recommended for cleaning the inside
of the washer.
g� Press the INICIO/PAUSA (Start/Pause) button to
start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, press INICIO/PAUSA once or twice
(depending on model). After the cycle has stopped, run
a ENJUAGAR Y EXPRIMIR (Rinse & Spin) cycle to rinse
cleaner from washer.
24
WASHER CARE (cont�)
2� Chlorine Bleach Procedure (Alternative):
a� Open the washer lid and remove any clothing
or items.
b� Add 236 mL (1 cup) of liquid chlorine bleach
to the bleach compartment.
NOTE: Use of more liquid chlorine bleach than is
recommended above could cause washer damage
over time.
c� Close the washer lid.
d� Do not add any detergent or other chemical
to the washer when following this procedure.
e� Select the cycle recommended for cleaning the inside
of the washer.
f� Press the INICIO/PAUSA (Start/Pause) button to
start the cycle.
NOTE: For best results, do not interrupt cycle. If cycle
must be interrupted, press INICIO/PAUSA once or twice
(depending on model). After the cycle has stopped, run
a ENJUAGAR Y EXPRIMIR (Rinse & Spin) cycle to rinse
cleaner from washer.
Cleaning the Dispensers
After a period of using your washer, you may find some
residue buildup in the washer's dispensers. To remove
residue from the dispensers, wipe them with a damp cloth
and towel dry. Do not attempt to remove the dispensers or
trim for cleaning. The dispensers and trim are not removable.
If your model has a dispenser drawer, however, remove the
drawer and clean it before or after you run the Clean Washer
cycle. Use an all-purpose surface cleaner, if needed.
Cleaning the Outside of the Washer
Use a soft, damp cloth or sponge to wipe away any spills.
Use only mild soaps or cleaners when cleaning external
washer surfaces.
IMPORTANT: To avoid damaging the washer's finish, do not
use abrasive products.
NON-USE AND VACATION CARE
Operate your washer only when you are home. If moving, or not
using your washer for a period of time, follow these steps:
1� Unplug or disconnect power to washer.
2� Turn off water supply to washer, to avoid flooding due
to water pressure surge.