Whirlpool 7MWTW1950EW 사용 및 관리 매뉴얼 - 페이지 19

{카테고리_이름} Whirlpool 7MWTW1950EW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7MWTW1950EW 33 페이지. Top-loading washer
Whirlpool 7MWTW1950EW에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지)

페이지 인쇄

Control Panel and Features

LLENADO PROFUNDO (DEEP FILL)

This option adds more water to the cycle, providing a deeper

fill.

TEMPERATURA (TEMPERATURE)

Temperature senses and maintains uniform water

temperatures by regulating incoming hot and cold water.

Select a wash temperature based on the type of fabric

and soils being washed. For best results and following the

garment-label instructions, use the warmest wash water safe

for your fabric.

On some models and cycles, warm and hot water may

be cooler than your previous washer.

Even in a cold- and cool-water wash, some warm water

may be added to the washer to maintain a minimum

temperature.

WASH CYCLE KNOB

Use the Wash Cycle knob to select cycles on your washer.

See "Cycle Guide" for detailed descriptions of cycles.

NIVEL DE SUCIEDAD (SOIL LEVEL)

Select the setting most suitable for your load. For heavily

soiled and sturdy fabrics, select Muy Sucio (Heavy) for more

wash time. For lightly soiled and delicate fabrics, select

Ligero (light) or Extra Ligero (extra light) for less wash time.

A lighter soil-level setting will help reduce tangling and

wrinkling.

ENJUAGUE ADICIONAL(EXTRA RINSE)

This option can be used to automatically add a second rinse

to most cycles.

INICIO/PAUSA (START/PAUSE) BUTTON

Press to start the selected cycle; press again to pause the

cycle and unlock the lid.

NOTE: Hold the Inicio/Pausa (Start/Pause) button for

3 seconds to cancel the wash cycle.

PROGRESS INDICATOR LIGHTS

Etapas de Lavado

The progress indicator lights show the status of a cycle. At

each stage of the process, you may notice sounds or pauses

different from traditional washers.

Not all features and options are available on all models.

Appearance may vary.

Llenando (Sensing Fill)

When the Inicio/Pausa (Start/Pause) button is pressed, the

washer will fill to an initial water level and begin sensing to

determine the load size. The washer will then continue filling

to the appropriate water level based on load size and proceed

to Wash.

If the lid is opened or the Inicio/Pausa (Start/Pause) button is

pressed, the cycle will pause. Closing the lid and/or pressing

the Inicio/Pausa (Start/Pause) button will resume the cycle. If

the cycle remains paused with the lid open for

10 minutes, the washer will pump out the water.

Lavado (Wash)

You will hear the agitator moving the load. The motor sounds

may change at different stages in the cycle. Wash time is

determined by the selected soil level.

Enjuague (Rinse)

You will hear sounds similar to the wash cycle as the washer

rinses and moves the load. You may hear the motor turning

on briefly (short hum) to move the basket while filling.

Drenado/Exprimido (Drain/Spin)

The washer spins the load at increasing speeds for proper

water removal based on the selected cycle.

Listo (Done)

Once the cycle is complete, this light will come on. For best

results, promptly remove the load.

Tapa (Lid Lock)

The lid-lock feature allows for higher spin

speeds. When lit, the lid is locked and cannot

be opened without pausing the cycle. When

the light is off, the lid can be opened.

To open the lid after it has been locked, press

Inicio/Pausa (Start/Pause). The lid will unlock

once washer movement has stopped. This

may take several minutes if the load was

high speed.

spinning at

(Start/Pause) while the lid is closed to resume

the cycle.

NOTE: Holding the Inicio/Pausa (Start/Pause) button will

cancel the cycle and cause the washer to drain.

Avoid opening the lid during sensing. The sensing process

will start over when the washer is restarted.

Press Inicio/Pausa