Whirlpool 7TWTW5015PW 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Whirlpool 7TWTW5015PW에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7TWTW5015PW 32 페이지.

페이지 인쇄

GROUNDING INSTRUCTIONS

For a grounded, cord-connected appliance:

This washer must be grounded. In the event of a malfunction

or breakdown, grounding will reduce the risk of electric shock

by providing a path of least resistance for electric current.

This washer is equipped with a cord having an equipment-

grounding conductor and a grounding plug. The plug must be

plugged into an appropriate outlet that is properly installed

and grounded in accordance with all local codes and

ordinances.

WARNING:

Improper connection of the equipment-

grounding conductor can result in a risk of electric shock.

Check with a qualified electrician or serviceman if you are in

doubt as to whether the appliance is properly grounded.

Do not modify the plug provided with the appliance — If it will

not fit the outlet, have a proper outlet installed by a qualified

electrician.

SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

Unpacking

WARNING

Excessive Weight Hazard

Use two or more people to move and install or uninstall

appliance.

Failure to do so can result in back or other injury.

Before you start: Remove shipping materials.

It is necessary to remove all shipping materials for proper

operation and to avoid excessive noise from washer.

1. Move Washer

Move washer to within 4 ft (1.2 m) of its final location; it must

be in a fully upright position.

NOTE: To avoid floor damage, set washer onto cardboard

before moving it and make sure lid is taped shut.

2. Remove shipping base

IMPORTANT: Removing shipping base is necessary for

proper operation.

To avoid damaging floor, place cardboard supports from

shipping carton on floor behind washer. Tip washer back and

place on cardboard supports. Remove shipping base (some

models require shipping base to be rotated 90° to the right

before pulling off). Set washer upright.

3. Remove packaging material from inside

washer

Remove tape from washer lid, open lid, and remove

packaging material from washer tub. Be sure that all parts

have been removed from inside washer.

NOTE: Keep packaging material for inside washer in case

you need to move washer later.

4. Free power cord

Firmly grasp power cord plug and pull to free from rear panel.

Gently place power cord over console to allow free access to

back of washer.

If the power cord is damaged, it must be replaced by the

manufacturer, by it's service agent authorized, or by qualified

personnel.