Whirlpool 7TWTW5057PW 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool 7TWTW5057PW에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 7TWTW5057PW 32 페이지.

9. Clear water lines

Run water for a few seconds through hoses into a laundry

tub, drainpipe, or bucket to avoid clogs. Water should run until

clear.

Make note of which hose is connected to hot water to help in

attaching hoses to washer correctly.

10. Connect inlet hoses to washer

IMPORTANT: To reduce risk of hose failure, replace the

hoses every 5 years. Record hose installation or replacement

dates for future reference.

� Do not overtighten hose or use tape or sealants on valve.

Damage to the valves can result.

� Periodically inspect and replace hoses if bulges, kinks,

cuts, wear, or leaks are found.

Attach hot water hose to red hot water inlet valve. Screw

coupling by hand until it is snug. Use pliers to tighten

couplings an additional two-thirds turn. Repeat with cold

water inlet valve.

11. Check for leaks

Turn on water faucets to check for leaks. A small amount of

water may enter washer. It will drain later.

12. Secure drain hose

Secure drain hose to laundry tub leg, drain standpipe, or inlet

hoses for wall standpipe with cable tie.

It is the responsibility of the installer to install and secure the

drain hose into the provided plumbing/drain in a manner that

will avoid the drain hose coming out of or leaking from the

plumbing/drain.

Level Washer

NOTE: Level washer properly to reduce excess noise and

vibration.

13. Check levelness of washer

Move the washer to its final location. Place a level on top

edges of washer. Use side seam as a guide to check

levelness of sides. Check levelness of front using lid, as

shown. Rock washer back and forth to make sure all four feet

make solid contact with floor. If washer is level, skip to

step 15.