Whirlpool 8316566 설치 지침 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool 8316566에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8316566 8 페이지.

4. If the washer is not level, move the washer out slightly, tip

back, prop up the front of the washer with the wood block and

adjust the feet up or down as necessary by twisting the feet.

Turn the feet clockwise to raise the washer or

counterclockwise to lower the washer. Repeat steps

1 through 4 until washer is level.

5. After the washer is in its final location and level, use a 14 mm

or ⁹⁄₁₆" open-end wrench to turn the nuts counterclockwise on

the feet tightly against the washer cabinet.

IMPORTANT: If the nuts are not tight against the washer

cabinet, the washer may vibrate.

8316566

1. Check the electrical requirements. Be sure that you have the

correct electrical supply and the recommended earthing

method. See "Electrical Requirements."

2. Check that all parts are now installed. If there is an extra part,

go back through the steps to see which step was skipped.

3. Check that you have all of your tools.

4. Check that the yellow shipping strap was completely removed

from the lower back of the washer.

5. Dispose of or recycle all packaging materials.

6. Check that the water faucets are on.

7. Check for leaks around faucets and inlet hoses.

Electrically earth this appliance.

Do not use an extension cord or an electrical portable

outlet device.

Failure to follow these instructions can result in death,

fire, or electrical shock.

8. Plug into an earthed outlet.

9. Remove the protective film on the console and any tape

remaining on the washer.

10. Read "Washer Use" in the Washer User Instructions.

11. To test and to clean your washer, measure ¹ ₂ of the normal

recommended amount of powdered or liquid detergent and

pour it into the washer basket or detergent dispenser (on

some models). Close the lid. Select any cycle, and then pull

the cycle control knob out to start the washer. Allow it to

complete one whole cycle.

Benton Harbor, Michigan 49022

Complete Installation

WARNING

Electrical Shock Hazard

8/05

Printed in U.S.A.