Whirlpool 8318507 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} Whirlpool 8318507에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8318507 10 페이지. 120-volt, 60-hz washer
페이지 인쇄
A
B
1.3 cm
(1/2")
C
D
E
A
approx. 41 cm
(16")
41
E
Leveling
washer
Stack two corner posts (A) on top of each other. Tilt washer
backwards and slide corner posts under washer 7.6 cm (3
inches) from each side of washer as shown.
Screw nut (B) down on legs to within 1.3 cm (1/2 inch) of
base (C).
Insert legs into correct holes at each front corner of washer until
nuts touch washer (D). DO NOT tighten nuts until washer is level.
Tilt washer backward and remove corner posts. Gently lower
washer to floor.
Move washer to its final location. Remove cardboard or
hardboard from under washer.
Tilt washer forward, raising back legs 2.5 cm (1 inch) off of floor
to adjust rear self-leveling legs. Drop washer to floor. Check
levelness of the washer by placing a carpenter's level on top of the
washer, first side to side; then front to back.
If washer is not level, adjust the front legs (E) up or down. Repeat
above step.
When washer is level, use wrench to turn nuts on front
legs up tightly against washer base. If nuts are not tight
against washer base, the washer may vibrate.
F
Securing
drain hose
NOTE: Use shipping strap to secure drain hose. Water
pressure could cause drain hose to come out of standpipe
or laundry tub if drain hose is not secured.
After shipping strap has been removed from washer, look for the
words "cut here" marked on the shipping strap, about 41 cm
(16 inches) from the plug end. Cut the shipping strap at this mark
(A).
Continued on page 8.
A
(
)
7.6
1.3
(
B
)
(
C
)
(
D
)
2.5
(
cut here
(
A
)
8
E
)
41
7