Whirlpool 8578566 사용 및 관리 매뉴얼 - 페이지 17

{카테고리_이름} Whirlpool 8578566에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8578566 44 페이지.

페이지 인쇄

First try the solutions suggested here to possibly avoid the cost of a service call...

Washer odor

Do you use High Efficiency (HE) detergent?

Use only High Efficiency (HE) detergent in this washer.

Have you cleaned the washer interior using the

recommended procedure? Your washer interior should be

cleaned at least once per month to reduce or avoid any

accumulation of mold or mildew odors. See "Washer Care"

for interior cleaning procedure.

Inspect the interior of the washer for lint and other debris that

may accumulate on the basket and rubber bellows. Remove

and dispose of any accumulation as necessary.

Leave the washer door open between cycles to allow the

washer interior to dry out.

Washer won't start

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death,

fire, or electrical shock.

Check the following:

Is the power cord plugged into a grounded 3 prong outlet?

Is the washer door firmly closed?

Has a cycle been selected, but START has not been pressed?

Was the door open after completion of last cycle?

Washer won't fill, wash or rinse

Check the following:

Is the power cord plugged into a grounded 3 prong outlet?

Is there power at the plug? Check electrical source or call

electrician.

Are the hot and cold water faucets turned on?

Is the water inlet hose kinked?

Are the water inlet valve screens clogged?

TROUBLESHOOTING

Washer stops

Check the following:

Is the power cord plugged into a grounded 3 prong outlet?

Is there power at the plug?

Check electrical source or call electrician.

Has a household fuse blown, or has a circuit breaker tripped?

Replace the fuse or reset the circuit breaker. If the problem

continues, call electrician.

Are you using an extension cord?

Do not use an extension cord.

Washer won't drain or spin

Is the drain hose clogged, or the end of the drain hose

more than 35" (88.9 cm) above the floor?

Is your voltage low?

Check electrical source or call electrician. Do not use an

extension cord.

Is the load balanced?

A single or bulky item may cause imbalance. Add more items

or redistribute the load.

Washer makes noise or vibrates

As water is drained from the washer, you may hear air being

pulled through the pump. This happens during the end of

draining. It is normal.

Is the washer level?

The washer must be level. The four feet should be properly

installed, and the nuts should be tightened against the

washer cabinet.

Did you remove the transport system?

Make sure four bolts and two bars have been removed. See

the "Installation Instructions."

Are you washing items with metal snaps, buckles or

zippers?

You may hear metal items touching the washer drum. This is

normal.

Is washer installed on a sturdy and solid floor?

Refer to the "Installation Requirements" for flooring

requirements. Noise and vibration may be reduced by placing

a piece of ¾" (19.1 mm) plywood underneath your washer.

The plywood may extend underneath both washer and dryer

to keep them at equal heights.

Washer leaks

Check household plumbing for leaks.

Dispensers clogged or leaking

Are the laundry products in the correct dispenser

compartment?

Add the correct amounts of HE detergent or fabric softener to

the correct compartments.