Whirlpool 8578566 사용 및 관리 매뉴얼 - 페이지 8

{카테고리_이름} Whirlpool 8578566에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8578566 44 페이지.

페이지 인쇄

Laundry tub drain system (view C)

The laundry tub requires a minimum carry-away capacity of

4.2 gal. (15.9 L) per minute.

The top of the laundry tub must be at least 23.5" (59.7 cm) above

the floor and no higher than 72" (183 cm) from the bottom of the

washer.

Floor drain system (view D)

The floor drain system requires a siphon break that may be

purchased separately. See "Tools and Parts."

The siphon break must be a minimum of 28" (71 cm) from the

bottom of the washer. Additional hoses might be needed.

The minimum carry-away capacity can be no less than 4.2 gal.

(15.9 L) per minute.

23.5 - 35"

(59.7 - 88.9 cm)

Connect Drain Hose

Proper connection of the drain hose will help protect your floors

from damage due to water leakage. To keep the drain hose from

coming off or leaking, it must be installed according to the

following instructions.

IMPORTANT: To ensure proper installation, this procedure must

be followed exactly.

For standpipe or laundry tub drain systems:

1. Check the drain hose to see that it is the proper length.

2. Install the U-shaped hose form to end of the drain hose to

create a hook-shaped end as shown.

A. Snap either end of the U-shaped hose form to the drain hose at the

point where the corrugation begins.

B. Bend drain hose over the form and snap into place.

3. Put hooked end of drain hose into laundry tub or standpipe.

There are two hoses provided with the machine. The hot water

hose is indicated with a red stripe running the length of the hose.

Insert new flat washers (supplied) into the straight hose fitting of

each inlet hose. Firmly seat the washers in the couplings.

Make sure the washer basket is empty.

1. Attach the hose with the red stripe to the hot water faucet.

2. Attach the other hose to the cold water faucet. Screw on

3. Using pliers, tighten the couplings with an additional

See illustrations A and B.

If the washer faucets and the drain standpipe are recessed,

put the hooked end of the drain hose in the standpipe as

shown. See illustration C.

To keep drain water from going back into the washer:

Do not straighten hooked end of drain hose. Do not force

excess drain hose into standpipe. Hose should be secure,

but loose enough to provide a gap of air.

NOTE: To avoid siphoning, do not seal the drain hose to the

standpipe.

Do not lay excess drain hose in bottom of laundry tub.

Do not force excess drain hose back into the rear of the

washer.

For floor drain installation, see kit number required under

"Tools and Parts."

Connect the Inlet Hoses

A. Coupling

B. Washer

Connect the inlet hoses to the water faucets

Screw on coupling by hand until it is seated on the washer.

coupling by hand until it is seated on the washer.

two-thirds turn.

NOTE: Do not overtighten. Damage to the valves can result.