Whirlpool 859991537390 사용자 설명서 - 페이지 14

{카테고리_이름} Whirlpool 859991537390에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 859991537390 19 페이지.

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

Switch o and unplug the washing machine before cleaning the water lter or draining residual water. If you used a

hot wash programme, wait until the water has cooled down before draining any water.

Clean the water lter regularly, to avoid that the water cannot drain after the wash due to obstruction of the lter.

If the water cannot drain, the display indicates that the water lter may be clogged.

Remove the kick panel: Using a screwdriver, do that which

is shown in the following gure.

Container for the drained water:

Place a low and wide container under the water lter in

order to collect the residual water.

Drain the water:

Slowly turn the lter counter-clockwise until all the water

has come out. Allow the water to ow out without

removing the lter. Once the container is full, close the

water lter by turning it clockwise. Empty the container.

Repeat the procedure until all the water has been drained.

Remove lter: Lay a cotton cloth beneath the water lter,

which can absorb a small amount of rest water. Then

remove the water lter by turning it out anticlockwise.

10.

Clean the water lter: remove residues in the lter and

clean it under running water.

11.

Insert the water lter and reinstall the plinth: Reinsert the

water lter again by turning it in clockwise direction. Make

sure to turn it in as far as it goes; the lter handle must be in

vertical position. To test water tightness of the water lter, you

can pour about 1 liter of water into the detergent dispenser.

Then reinstall the plinth.

User manual