Whirlpool 8MWTW2024 사용 및 관리 매뉴얼 - 페이지 17

{카테고리_이름} Whirlpool 8MWTW2024에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 8MWTW2024 44 페이지. Top-loading high efficiency washer
Whirlpool 8MWTW2024에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (41 페이지)

페이지 인쇄

TROUBLESHOOTING

Electrical shock hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire

or electrical shock.

First try the solutions suggested here to possibly avoid a service call.

If you experience

Washer not performing as expected

There is not enough

water in the washer

Washer won't run or fill,

washer stops working.

Wash light stays ON

(Which means that the

washer was not able to

fill the drum with water

properly)

09-Feb-2018 07:28:55 EST | RELEASED

WARNING

Possible Causes

The load is not completely

covered by water

Check for proper water

supply.

Check proper electrical

supply.

Normal washer operation.

Washer may be overloaded.

Using too much detergent.

The washer is in detection

stage (Autolevel)

In some European factories the letter "W" of the part code mentioned herein will be automatically

This is normal. The washer will add the optimum amount of water for each

load. For better detection of load size and optimal operation of your washer,

introduce dry clothes.

Both hoses must be attached and have water flowing to inlet valve.

Both Hot and Cold water faucets must be turned on.

Check that inlet valve screens have not become clogged.

Check for any kinks in inlet hoses, which can restrict water flow.

Plug power cord into a grounded 3 prong outlet.

Do not use an extension cord.

Ensure there is power to outlet.

Reset a tripped circuit breaker. Replace any blown fuses.

NOTE: If problems continue, contact an electrician.

Lid must be closed for washer to run.

Washer will pause during certain phases of cycle.

Do not interrupt cycle.

Washer spins the load and creates humming sounds. This is normal

Remove several items, rearrange load evenly in basket and add detergent.

Close lid to continue the cycle.

Do not add more than 1 or 2 additional items after cycle has started to avoid

overloading or unbalancing.

Suds from regular detergents can slow or stop the washer. Always measure

detergent and follow detergent directions based on your load requirements.

To remove suds, cancel cycle.

Select DRAIN & SPIN and press Start/Pause.

Do not add more detergent.

For about 1 minute the washer will rotate until the load size is set.

replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")

Solution