Whirlpool ADP 5755 WH 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} Whirlpool ADP 5755 WH에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool ADP 5755 WH 36 페이지.

Whirlpool ADP 5755 WH 조립 지침 매뉴얼
GB
1.
Water connection
-
Connection to the mains water supply must be carried out by a qualified technician in compliance
with the manufacturer's instructions and applicable local safety regulations.
-
All local water board regulations must be complied with. Water supply pressure: 0.03 - 1.0 MPa.
-
The inlet hose must be securely clamped to the water tap to prevent leaks.
The inlet water temperature varies according to the model installed. Inlet hose marked: "25°C Max":
-
up to a maximum of 25°C. Other models: up to a maximum of 60°C.
-
Depending on the appliance model, the solenoid valve of the inlet hose will be activated by the
mains voltage (see ** assembly instructions).
-
Make sure the inlet and drain hoses are kink-free and are not crushed.
-
Fix the drain hose to the siphon with a clamp to prevent it from coming off during operation.
When installing the appliance, make sure water can drain freely (remove the siphon plug if
-
necessary).
-
Do not use old or damaged hoses. Use only the hoses provided or new ones, which can be
requested from the After-Sales Service.
-
If hoses are not long enough, contact your local dealer.
-
Do not cut hoses and, in the case of appliances fitted with a waterstop system, do not immerse
the plastic casing containing the inlet hose in water.
-
Before using the appliance for the first time, check the water inlet and drain hose for leaks.
2.
Electrical Connection
-
All local electricity board regulations must be complied with.
-
Voltage information is shown on the rating plate mounted inside the door on the right hand side.
The appliance must be earthed as prescribed by law.
-
-
Do not use extension leads or multiple adapters.
-
If the power cable is damaged, replace it with an identical one. The power cable must only be
replaced by a qualified technician.
-
After appliance installation, the mains plug must be easily accessible so that the appliance can be
unplugged if necessary at any time.
For Austria:
If a fault current switch is fitted upline of the appliance, this must be pulse current-sensitive.
3.
Assembly instruction
-
During assembly the appliance must be unplugged from the mains.
-
Set any electrical screwdrivers to a low torque.
-
Attention: when transporting and assembling the appliance, always wear gloves to protect
fingers / hands from sharp edges and corners.
-
Be careful with uneven installation surfaces: regulate the foot height.
For dishwashers with decor panel, fit the decor panel before the rounded plinth.
-
-
The decor panel, if not supplied, is available from After-Sales Service.
-
Removing the rounded plinth (see page 34), fitting (see page 35).
4.
General indications
-
The appliance must only be used in the household and according its purpose.
Do not use the dishwasher until it has been fully assembled.
-
-
Do not use the dishwasher if it has been damaged in transit. Contact After-Sales Service or your
local dealer.
Before carrying out any cleaning or maintenance operations, unplug the appliance and turn off the
-
water tap. The same applies in the event of a malfunction.
-
Do not use abrasive products or alcohol on the control panels.
All sizes in this installation instruction are given in millimetres.
-
-
Packaging varies according to the dishwasher model.
4