Whirlpool AWE 6416 사용 설명서 지침 - 페이지 18

{카테고리_이름} Whirlpool AWE 6416에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWE 6416 19 페이지. 5kg, 1000rpm top loader washing machine awe 6517

IFU-TL HR GB.fm Page 18 Friday, November 7, 2008 2:30 PM

Water stop anti-flooding system

(see inlet hose type as shown on the right - depending on

model)

• Screw the hose to the water supply tap. Turn the tap fully

on and check the water-tightness of the connection.

• The washing machine must not be connected to the

mixing tap of a non-pressurized water heater!

• The inlet hose and the plastic enclosure contain

(depending on model) electrical components: do not cut

the hose and do not immerse the enclosure in water.

• If the flexible hose is damaged, unplug the washing

machine from the mains immediately, turn off the tap and

replace the hose.

If the flexible hose is too short, replace it with a 3 m Water

Stop hose (available from After-Sales Service or from your

dealer). This operation must be carried out exclusively by a

qualified technician.

Connect the water drain hose

1. Unhook the drain hose from the left clip, see arrow "A"

on picture.

Important:

Do NOT loosen the drain hose from the right

connection, see arrow "B" on picture. Otherwise, there

is the risk of leakage and of scalding with hot water.

2. Fix the "U" bend ("C") at the very end of the drain hose.

3. Connect the drain hose to the siphon or hook it over the

edge of a sink with the "U" bend and fix it properly.

Small hand basins are not suitable.

The edge of the sink must be no more than 100 cm from

the floor.

If you need to add an extension, use a flexible hose of the

same size and secure the unions with screw-on hose clips.

Maximum overall drain hose length: 2.50 m.

Maximum drain height ("U" bend): 100 cm.

Minimum drain height: 55 cm.

Important:

Make sure there are no kinks in the drain hose and take

precautions against it falling while the washing machine is

running.

Black process 45.0° 100.0 LPI

GB 18