Whirlpool AWE 6517 AWE 6517 사용 설명서 지침 - 페이지 19

{카테고리_이름} Whirlpool AWE 6517 AWE 6517에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWE 6517 AWE 6517 19 페이지. 5kg, 1000rpm top loader washing machine awe 6517

페이지 인쇄

IFU-TL HR GB.fm Page 19 Friday, November 7, 2008 2:30 PM

Do not use extension leads or multi sockets.

Electrical connections must be made in accordance with local regulations.

1) Warning - this washing machine must be earthed

This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has

been checked for correct earth continuity.

If the fitted plug is not suitable for your socket outlet, or if the machine's mains lead is not fitted with a plug,

you should fit a suitable new, good quality plug by following the instructions in (2) below.

Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be

inserted into a socket.

2) CONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician

The wires in the mains lead are coloured in accordance with the following code:

BLUE - "NEUTRAL" ("N")

BROWN - "LIVE" ("L")

GREEN AND YELLOW - "EARTH" ("E")

2.2) Non-polarized plugs (e.g. 2 pin with side earth contact)

The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two

wires should be connected to the two pins, irrespective of colour.

Black process 45.0° 100.0 LPI

ELECTRICAL CONNECTION

To fit a new plug, proceed as follows:

2.1 Polarized Plugs (e.g. 3 pin, 13 amp plug conforming to

BS 1363A)

a. The GREEN AND YELLOW wire must be connected to the

terminal in the plug which is marked with the letter "E" or by

the Earth symbol

b. The BLUE wire must be connected to the terminal which is

marked with the letter "N" or coloured blue.

c. The BROWN wire must be connected to the terminal which is

marked with the letter "L" or coloured brown.

FUSE REPLACEMENT

If the mains lead of this washing machine is fitted with a BS 1363A 13

amp fused plug, replace the fuse only with an A.S.T.A. approved type

conforming to BS 1362 and proceed as follows:

Remove the fuse cover (A) and the fuse (B).

Fit the replacement 13 A fuse into the fuse cover.

Refit both into the plug.

For all other types of plug, the supply socket should be protected by

a 16 A fuse or circuit breaker at the distribution board.

GB 19

or coloured green and yellow.