Whirlpool AWM 5100 사용 설명서 지침 - 페이지 10
{카테고리_이름} Whirlpool AWM 5100에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWM 5100 19 페이지.
페이지 인쇄Start delay
(depending on model)
1.Select the programme and temperature, any additional options and the spin speed.
2.Press the "On/Off" button. The display flashes "0" for 6 seconds.
3.During these 6 seconds press the "Start Delay" button and select delay time: 0,3,6,9 hours.
4.The programme will start at the desired time, or after 6 seconds if "0" is selected.
•
To change the start delay: press the "Start Delay" button to select time.
•
To cancel the start delay: press the "Start Delay" button until "0" appears: the selected programme
will then start.
•
If options are changed during the delay time period: the programme will start with newly selected options.
•
If the programme is changed during the delay time period: "Start Delay" will switch automatically
to "0". Reselect the Start Delay time to activate.
N.B. With liquid detergent, a dosing aid placed directly in the drum should be used if a start delay has
been selected.
Door lock
The door locks automatically after the programme start until the end of the programme.
If the programme selector is moved to the "Stop" position or if the electricity supply is interrupted,
then after approximately one minute the door is released.
In this case do not open the door, because hot water could be released from the appliance.
Programme end
The programme selector knob is at the stop position.
1.Press the "On/Off" button. The indicator light turns off.
2.Cancel the special options by pressing the appropriate buttons.
3.Turn the water supply tap off.
4.Wait for the door to unlock (about one minute).
5.Open the door and unload the machine.
N.B. Do not fully close the door but leave it ajar to allow the drum to dry out.
Changing programme
1.Press the "On/Off" button. The indicator lights turns off.
2.Select the new programme.
3.Press the "On/Off" button. The new program will re-start.
For this programme do not add any further detergent.
Changing options
The options can be selected or deselected without switching off the appliance.
Programme interruption or pause
To interrupt the running programme for a certain period and continue it at a later time:
1.Press the "On/Off" button.
2.Following the desired pause press the "On/Off" button once again.
Cancelling the programme
If the current programme is to be terminated prematurely and cancelled, the water must be pumped out
first before the door can be opened:
1.Press the "On/Off" button to switch off the appliance.
2.Set the programme selector to programme setting "Drain".
3.Press the "On/Off" button in order to start the "Drain" programme.
26