Whirlpool AWM 5145/5 프로그램 차트 - 페이지 2

{카테고리_이름} Whirlpool AWM 5145/5에 대한 프로그램 차트을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWM 5145/5 3 페이지.

페이지 인쇄

CONSUMPTION DATA

Load

Programme

Cotton 95°

Cotton 60°

Cotton 40°

Daily 40°

Synthetics 40°

Delicate 40°

Wool 40°

Silk 30°

Prewash might increase programmme duration. Consumption values were measured in normalized conditions in

compliance with Standard IEC/EN 60 456.

Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure

and temperature, the load and the type of wash.

ADD DETERGENTS, CLOSE THE DOOR AND

SELECT THE PROGRAMME

Add the detergent as described in the programme

table or in the chapter "Detergents and Additives"

in the booklet.

1. Open the tap.

2. Set the programme selector to the desired

programme.

3. Set the spin selector to the desired speed.

4. Special options can be selected.

5. Check that the door is well closed and turn on

the washing machine by pressing the "ON/

OFF" button. The indicator lights up, indicating

that the washing machine is on.

Water

Energy

(kg)

(l)

(kWh)

5.0

1.90

5.0

0.95

4.5

0.60

3.0

0.50

2.5

0.60

1.5

0.60

1.0

0.45

1.0

0.30

SELECT ANY DESIRED OPTION

"Quick Wash" button

• For quick, economical washes.

• Ideal for minimum loads of lightly-soiled articles.

Note: reduce the detergents quantity.

"Rinse Hold" button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to

avoid creasing and prevent colours from

changing.

• This option is particularly recommended for the

programme "Synthetics" or "Delicates".

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want

to drain only.

Terminate the "Rinse Hold" option:

• Press the "Rinse Hold" button again; the

programme will terminate automatically with the

final spin cycle for the present wash programme.

• If you do not wish to spin the clothes, turn the

programme selector knob counterclockwise to

the "Drain" programme.

"Cold Wash" button

• With this option water is heated only up to 20°C.

PROGRAMME CHANGE

To reselect a programme when a cycle has already

Approx.

Programme

begun:

Duration

1. Switch off the appliance by pressing the

(hours:minutes)

"ON/OFF" button.

2:05

2. Select the new programme.

2:25

3. Start the programme by pressing the "ON/

2:10

OFF" button.

1:00

1:25

0:50

PROGRAMME END

0:45

1. At the end of the programme the programme

0:45

selector moves to the stop position.

2. To unload the machine wait for the door to

unlock (about 1 minute).

3. Switch off the appliance, open the door and take

out the laundry.

4. Close the tap and leave the door ajar to allow

the drum to dry out.

NOTES AND INDICATIONS FOR USE

•

WATER LEVEL

It may not be visible as the cycle is optimised

for a minimum water consumption without

compromising washing results.

•

SPIN SPEED CONTROL

Spin speed may be reduced automatically or

may even be excluded in the case of small

loads with highly absorbent garments (e.g.

bathrobes, bathmat).

This control avoids cloth and machine damage

and excessive vibrations and consequent noise

produced by the machine due to load

unbalance: by selecting high spin speeds the

noise level increases.

•

MOTOR NOISE

The running noises of the new, electronically-

controlled motor are not the same as the ones

you are used to from your old appliance. Don't

be surprised - modern technology has a

modern sound.

•

CLEANING THE FILTER

To ensure an impeccable function of the pump,

check the filter regular and clean it if necessary.

Whirlpool is a registered trademark of Whirlpool USA

5019 301 10192