Whirlpool AWM 6120 사용 설명서 지침 - 페이지 13

{카테고리_이름} Whirlpool AWM 6120에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWM 6120 22 페이지. Front-loading washer
Whirlpool AWM 6120에 대해서도 마찬가지입니다: 서비스 매뉴얼 (19 페이지)

페이지 인쇄

REMOVING THE FILTER

1. Switch off the appliance and unplug it.

2. Remove the coloured insert from the detergent

dispenser and use it to open the filter cover.

3. Place a bowl beneath the filter.

4. Turn the filter slowly anti-clockwise until the grip is

vertical; do not extract filter as yet.

5. Wait until all the water has drained out.

6. Now unscrew the filter completely and extract it.

7. Remove any foreign material from the filter.

8. Make sure the pump impeller is not obstructed.

9. Insert the filter and screw it fully down in a clockwise

direction (until the grip is horizontal).

10.Close the cover.

11.Pour 0.5 l of water into the detergent dispenser to

reactivate the "Eco System".

12.Connect the appliance to the electrical socket.

13.Select a programme and start it.

Check the filter two or three times a year and clean it if

necessary.

• Check the filter if the appliance is not draining properly

or if it fails to perform spin cycles.

• Remove the filter if the pump is blocked by an object

(buttons, coins, safety pins, etc.).

IMPORTANT: Make sure the water has had time to

cool before draining the appliance.

DRAINING RESIDUAL WATER

• Drain the residual water as described in the "Removing the Filter" chapter (points 1 to 8).

• To drain the residual water from the pump, bend the machine frontward and operate as per

points 9 and 10 of the previous chapter.

When should I drain residual water?

• Before transporting (moving) the machine.

• If the appliance is installed in a room subject to sub-zero temperatures.

It is best in this case to drain the machine after every wash.