Whirlpool AWO/D 050 사용 설명서 지침 - 페이지 6

{카테고리_이름} Whirlpool AWO/D 050에 대한 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool AWO/D 050 14 페이지. 5kg, 1000rpm fully integrated washing machine awo/d 049
Whirlpool AWO/D 050에 대해서도 마찬가지입니다: 브로셔 (2 페이지)

페이지 인쇄

30110447GB.fm Page 6 Thursday, May 10, 2007 12:35 PM

Where to put detergent and additives

The detergent drawer has three chambers (fig. "A").

Prewash Chamber

• Detergent for the prewash

Main Wash Chamber

• Detergent for the main wash

• Stain remover

• Water softener

Softener Chamber

• Fabric softener

• Liquid starch

Pour additives only up to the "MAX" mark.

Using chlorine bleach

• Wash your laundry in the desired programme (Cotton, Synthetics),

adding an appropriate amount of chlorine bleach to the SOFTENER

chamber (close the detergent dispenser carefully).

• Immediately after end of programme, start the "Rinse and Spin"

programme to eliminate any residual bleach smell; if you want,

you can add softener.

Never put both chlorine bleach and softener into the softener

chamber at the same time.

Using starch

• Select the "Rinse and Spin" programme and check that the spin

speed is adjusted to not more than 800 rpm.

• Start the programme, pull out the detergent dispenser so that you

can see approximately 3 cm of the softener chamber.

• Pour the starch solution prepared into the softener chamber

while the water is running into the detergent dispenser.

How to position the separator in the main wash

chamber for powder or liquid detergent

For use with powder detergent: place the separator in the higher

position.

Lift the separator until its top can be reclined. Place its hooks on the

upper end of the back guide rails and slightly push the separator

down to fix it (fig. "B" and "C").

A gap should remain between the separator and the bottom of the main

wash chamber, if the separator has been correctly installed (fig. "B" and

"C").

For use with liquid detergent: place the separator in the lower position.

Secure the separator in the chamber using the front guide rails.

Position the separator so that it touches the bottom of the main

wash chamber

(fig. "D").

Black process 45.0° 100.0 LPI

Separator

Hooks

GB 6

( )

}

Separator

Guide

Rails