Ariston PH 941MS 설치 및 사용 설명서 지침 - 페이지 8

{카테고리_이름} Ariston PH 941MS에 대한 설치 및 사용 설명서 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston PH 941MS 13 페이지. Built-in cooking table
Ariston PH 941MS에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 설치 및 사용 설명서 (34 페이지), 사용 설명서 (20 페이지)

페이지 인쇄

The following instructions are directed at the qualified

installer so that the installation and maintenance

proceedures may be followed in the most professional and

expert manner possible. Important: Unplug the electrical

connection before performing any maintenance or

regulation upkeep work.

Positioning for gas hob

Important: this unit may be installed and used only in

permanently ventilated rooms according to the British

Stancards Codes Of Practice: B.S. 6172 / B.S. 5440, Par.

2 and B.S. 6891 Current Editions. The following

requirements must be observed:

a) The room must be fitted with a ventilation system which

vents smoke and gases from combustion to the outside.

This must be done by means of a hood or electric

ventilator that turns on automatically each time the hood

is operated.

In a chimney stack or branched flue.

(exclusively for cooking appliances)

b) The room must also allow for the influx of the air needed

for proper combustion. The flow of air for combustion

purposes must not be less than 2 m

capacity. The supply of said air can be effected by means

of direct influx from the outside through a duct with a

inner cross section of at least 100 cm² which must not be

able to be accidentally blocked. Those appliances which

are not fitted with a safety device to prevent the flame

from accidentally going out must have a ventilation

opening twice the size otherwise required, i.e. a minimum

of 200cm

(Fig. A). Otherwise, the room can be vented

indirectly through adjacent rooms fitted with ventilation

ducts to the outside as described above, as long as the

adjacent rooms are not shared areas, bedrooms or

present the risk of fire (Fig. B).

Detail A

Examples of ventilation holes

for comburant air.

Fig. A

Installation Instructions for built-in

Directly to the Outside

/h per kW of installed

Adjacent

Room to be

Room

Vented

Enlarging the ventilation slot

between window and floor.

Fig. B

c) Intensive and prolonged use of the appliance may ne-

cessitate supplemental ventilation, e.g. opening a window

or increasing the power of the air intake system (if present).

d) Liquidified petroleum gases are heavier than air and, as

a result, settle downwards. Rooms in which LPG tanks

are installed must be fitted with ventilation openings to

the outside in order to allow the gas to escape in the

event of a leak. Therefore, LPG tanks, whether empty or

partially full, must not be installed or stored in rooms or

spaces below ground level (cellars, ect.). It is also a good

idea to keep only the tank currently being used in the

room, making sure that it is not near sources of heat

(ovens, fireplaces, stoves, etc.) that could raise the internal

temperature of the tank above 50°C.

Installation of built-in stove tops

The gas hobs are prepared with protection degree against

excessive heating of type X, the appliance can therefore

be installed next to cabinets, provided the height does not

exceed that of the hob. For a correct installation of the

cooking hob the following precautions must be followed:

a) The hob may be located in a kitchen, a kitonen/diner

or bed sitting room, but not in a bathroom or shower

room.

b) The furniture standing next to the unit, that is higher

than the working boards, must be placed at least

110mm from the edge of the board.

c) The cabinets should be positioned next to the hood at

a height of at least 420 mm (Fig. C).

d) Should the hob be installed directly under a cupboard,

the letter should be at least 700mm (millimetres) from

the worktop, as shown in Fig. C.

e) The dimensions of the room for the furniture must be

those indicated in the figures in the last two pages of

the cover. Fixing hooks are provided which allow to

place the hob plate on work tops that measure from

20 to 40 mm in thickness (see Fig. D). To obtain a good

fixing of the hob plate it is advisable to use all the hooks

supplied.

min. 55 mm.

HOOD

900

Min.

mm.

Fig. C

835 mm.

Fig. D