Whirlpool CFCR70211 사용자 설명서 - 페이지 15

{카테고리_이름} Whirlpool CFCR70211에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool CFCR70211 40 페이지.

User manual

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used

a hot wash programme, wait until the water has cooled down before draining any water.

Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter.

If the water cannot drain, the display indicates that that the water filter may be clogged.

Remove the kick panel: Using a screwdriver, do that which

is shown in the following figure.

Container for the drained water:

Place a low and wide container under the water filter

in order to collect the residual water.

Drain the water:

Slowly turn the filter counter-clockwise until all the

water has come out. Allow the water to flow out without

removing the filter. Once the container is full, close the

water filter by turning it clockwise. Empty the container.

Repeat the procedure until all the water has been

drained.

Remove filter: Lay a cotton cloth beneath the water filter,

which can absorb a small amount of rest water. Then

remove the water filter by turning it out anticlockwise.

10.

Clean the water filter: remove residues in the filter and

clean it under running water.

11.

Insert the water filter and reinstall the plinth: Reinsert

the water filter again by turning it in clockwise

direction. Make sure to turn it in as far as it goes; the

filter handle must be in vertical position. To test water

tightness of the water filter, you can pour about 1 liter

of water into the detergent dispenser. Then reinstall the

plinth.