Ariston PK 741 RQO GH AG 사용 설명서 - 페이지 8
{카테고리_이름} Ariston PK 741 RQO GH AG에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston PK 741 RQO GH AG 42 페이지. 60-75cm
![Ariston PK 741 RQO GH AG 사용 설명서](/uploads/products/server2/679681/679681.jpg)
Start-up and use
! The position of the corresponding gas burner or
GB
electric hotplate* is shown on every knob.
Gas cooker hobs are equipped with discrete power
adjustment that allows for accurately adjusting the
flame to 5 different power levels. Thanks to this
system, gas hobs are also capable of guaranteeing
the same cooking results for each recipe, as the
optimal power level for the desired type of cooking
can be identified in an easier, more accurate way.
Gas burners
Each burner can be adjusted to one of the following
settings using the corresponding control knob:
•
Off
Maximum
Minimum
To light one of the burners, hold a lit match or lighter
near the burner and, at the same time, press down
and turn the corresponding knob anti-clockwise to the
maximum setting.
Since the burner is fitted with a safety device, the
knob should be pressed for approximately 2-3
seconds to allow the automatic device keeping the
flame alight to heat up.
When using models with an ignition button, light the
desired burner pressing down the corresponding
knob as far as possible and turning it anticlockwise
towards the maximum setting.
! If a flame is accidentally extinguished, turn off the
control knob and wait for at least 1 minute before
trying to relight it.
To switch off the burner, turn the knob in a clockwise
direction until it stops (when reaches the "•" position).
Discrete flame adjustment
The selected burner can be adjusted - by means of
the knob - to 5 different power levels.
To shift between levels, simply turn the knob
towards the desired power level.
A click signals the passage from one power level to
the other.
8
The selected power level is
indicated by the
corresponding symbol
(symbols
) and, on
hobs equipped with a
display, by the LEDs that turn
on (5 = max. power; 1 = min. power). The system
guarantees accurate flame adjustment and uniform
cooking results by facilitating selection of the
desired power level.
The "double-flame" burner
This gas burner consists of two concentric flame
rings that can operate jointly or independently (in
case of dual-control only).
As the burner is fitted with a safety device, the
knob should be pressed down for approximately 2-3
seconds until the device keeping the flame
automatically alight heats up.
Dual control:
Each ring comprising the burner has its own control
knob:
The knob marked with the symbol
outer ring.
The knob marked with the symbol
inner ring.
To activate any one of the two rings, press the
corresponding knob and turn it anti-clockwise to the
maximum power setting
In order to use the double-flame burner to its full
potential, avoid simultaneously setting the inner
ring to minimum power and the outer ring to
maximum power.
Single control:
The rings comprising the burner are activated
through a single control knob.
To simultaneously turn on both rings, position the
knob on the symbol
(max.) -
and turn the knob anti-clockwise.
To turn on the inner ring only, position the knob on
the symbol
(max.) -
(min.) then press and turn
the knob clockwise.
(to switch modes, it is necessary to switch off the
burner).
To switch off the burner, press and turn the knob
clockwise until it stops (when it reaches the "•"
position).
Ceramic Glass Module*
This cooktop is fitted with dual-ring radiant heating
elements located beneath the glass. It is possible to
turn on only the circular part of the elemement
(identified by the letter "A") or the cooking surface
*
Only available on certain models.
controls the
controls the
.
(min.) then press