Whirlpool WASHER 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Whirlpool WASHER에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WASHER 20 페이지. Washing machine
Whirlpool WASHER에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (16 페이지), 설치 지침 매뉴얼 (27 페이지), 사용자 지침 (8 페이지), 사용자 지침 (20 페이지), 사용자 지침 (24 페이지), 사용자 지침 (8 페이지), 사용자 지침 (15 페이지), 사용 및 관리 매뉴얼 (40 페이지), 설치 지침 매뉴얼 (16 페이지), 사용자 지침 (8 페이지), 프로그램 차트 (2 페이지), 설치 지침 (5 페이지), 설치 지침 매뉴얼 (8 페이지)

페이지 인쇄
Whirlpool WASHER 설치 지침 매뉴얼
2.
Connect drain hose form
For a laundry tub or standpipe drain, connect the drain hose
form. For a floor drain, do not install drain hose form. You
may need alternate parts with separate directions. See
"Tools and Parts" to determine what you may need.
Feed hose into one end of form. Bend hose and feed through
other side, anchoring form on smooth sections of hose. The
hose must extend 4.5" (114 mm) beyond the form.
3.
Place drain hose in standpipe
4.5"
(114 mm)
Place hose into standpipe (shown in picture) or over side
of laundry tub.
IMPORTANT:
To keep drain water from going back into
the washer:
Do not force excess drain hose into standpipe. Hose
■
should be secure but loose enough to provide a gap
for air.
Do not lay excess hose on the bottom of the laundry
■
tub.
6

CONNECT INLET HOSES

1.
Insert new flat washers
A
A. Coupling
B. Washer
IMPORTANT:
To avoid leaks, check that your water inlet
hoses have flat washers at both ends. Washer must be
connected to water faucets with new inlet hoses with flat
washers (not provided). Do not use old hoses. Do not use
hoses without washers.
2.
Connect inlet hoses to water
faucets
Make sure the washer basket is empty. Attach the hose
labeled hot to hot water faucet. Screw on coupling by hand
until it is seated on washer. Use pliers to tighten couplings
an additional two-thirds turn. Repeat this step with the hose
labeled cold for the cold water faucet. Both hoses must
be connected for washer to work properly.
IMPORTANT:
Do not overtighten or use tape or sealants
on valve when attaching to faucets or washer. Damage
can result.
HELPFUL TIP:
Make note of which hose is connected
to hot water to help in attaching hoses to washer correctly.
3.
Clear water lines
Run water for a few seconds through hoses into a laundry
tub, drainpipe, or bucket to avoid clogs. Water should run
until clear. Check the temperature of the water to make sure
that the hot water hose is connected to the hot water faucet
and the cold water hose is connected to the cold water faucet.
B