Ariston A45V 수리 매뉴얼 - 페이지 6

{카테고리_이름} Ariston A45V에 대한 수리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ariston A45V 11 페이지.

3. PROGRAM SELECTOR

• To remove the Program Selector, first remove the Program Selector Knob by using a small screwdriver to pry it off the Selector

Shaft (Fig. 3-1), remember to mask the area to prevent damaging the Control Panel. With the Program Selector Knob removed,

remove the two (2) Phillips screws (Fig. 3-2). Before removing the Program Selector note the wiring configuration (Fig. 3-3).

• To remove the Control Panel, first remove the Program Selector Knob as described in Section 3. Then remove the five (5) Phillips

Control Panel Mounting Screws (Fig. 4-1). There are two screws located on the right side (Fig. 4-2), two screws located on the left

side (Fig. 4-4) and a single screw located in the middle. To remove the middle screw, rotate the Drum until one of the access holes

lines up with the screw, now place your Phillips Screwdriver into the access well and remove the screw (Fig. 4-3).

REPAIR MANUAL

Fig. 3-1

Fig. 4-2

Fig. 3-2

Note: Alignment of the

Drum and the Screw

Access Hole.

Fig. 4-3

A 45 V

Fig. 3-3

Fig. 4-1

Fig. 4-4

Page: 3