Whirlpool 3ED27DQ 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool 3ED27DQ에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3ED27DQ 24 페이지. No-frost refrigerator-freezers with thirst crusher
Whirlpool 3ED27DQ에 대해서도 마찬가지입니다: 사용 및 관리 매뉴얼 (30 페이지), 사용 및 관리 매뉴얼 (30 페이지)

페이지 인쇄

The water

dispenser

Chilled water comes from a tank behind the meat

drawer. It holds approximately

1.5 L (1% quarts).

When the refrigerator is first hooked up, press

the water dispenser bar with a glass or jar until

you have drawn and discarded 1.9 or 2.8 L (2 or

3 quarts). The water you draw and discard will

rinse the tank and pipes.

Allow several hours to chill a new tankful.

NOTE: The small tray beneath the dispenser is

designed to evaporate small spills. There is no

drain in this tray. Do not pour water into it.

To dispense

water:

1. Press a sturdy glass against the water

dispenser bar.

2. Remove the glass to stop dispensing.

NOTE: Dispense enough water every week to

maintain a fresh supply.

The dispenser

light

To turn on night light, slide dispenser LIGHT

switch to the left. See page 17 for directions for

changing the dispenser light bulb.

Using

the automatic

ice mawer

Here are a few things you will want to know about

your automatic ice maker:

The ON/OFF lever is a wire signal arm.

Down

to make ice automatically.

to shut off the ice maker.

NOTE: Do not turn ice maker on until it is

connected to the water

SUDDIV.

Instructions

for

ice maker water supplv

hook LID are attach-

ed to the back of the refriaerator

cabinet.

It is normal for ice crescents to be attached by a

corner. They will break apart easily.

The ice maker will not operate until the freezer

is cold enough to make ice. This can take

overnight.

If ice is not being made fast enough and more

ice is needed, turn the Refrigerator Control

toward a higher number. Wait a day and, if

necessary, turn the Freezer Control toward C.

Good water quality is important for good ice

quality. It is not recommended

that the ice

maker be connected to a softened water supply.

Water softener chemicals, such as salt from a

malfunctioning

softener, can damage the ice

maker mold and lead to poor ice quality. If a

softened water supply cannot be avoided, it is

important that the water softener be well

maintained and operating properly.

Raise

signal

arm to

stop ice

maker.

Lower

signal

arm to

start ice

maker.