Whirlpool 3ET16NKXDG00 사용 및 관리 매뉴얼 - 페이지 18

{카테고리_이름} Whirlpool 3ET16NKXDG00에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3ET16NKXDG00 29 페이지. No-frost refrigerator-freezer

Removing

the pull-out

freezer

floor

(on some

models)

The freezer floor pulls out for easier access to

foods in the back of the freezer and for easier

cleaning.

To remove the freezer floor:

1. Lii both back "fences" up and out.

2. Pull floor out about 1 inch (2.5 cm) with one

hand around the air tower section (center

back) and one hand at center front.

3. Lii floor up at rear until hooks release from

cabinet.

4. Pull floor out the rest of the way.

To replace the freezer floor:

1. Position back of floor into freezer opening.

2. Slide floor straight in until hooks drop into

place at rear of cabinet.

3. Replace "fences" by aligning pins with

sockets in the floor. Push down until they

snap into place.

Using

the ice cube trays

If cubes are not used, they may shrink. The

moving cold air starts a slow evaporation.

The longer you store cubes, the smaller

they get.

To remove Ice:

1. Hold tray at both ends.

2. Twist slightly.