Whirlpool 4322658A 매뉴얼 - 페이지 16

{카테고리_이름} Whirlpool 4322658A에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4322658A 48 페이지. In-door ice system

페이지 인쇄

REMOVING THE ICE MAKER & THE WATER FILL TUBE

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Replace all panels before operating.

Failure to do so can result in death or

electrical shock.

Disconnect the unit from the electrical

supply.

To remove the ice maker:

a) Open the freezer door.

b) Close the spring-loaded emitter door

and open the ice maker door.

Emitter Door Open

c) Push the ice maker door to the left so

that the right pin disengages from the

pivot arm, then lift the pin out of the

pivot, and remove the left pin.

Ice Maker

Door Pin

Open Ice Maker Door

Emitter Door Closed

Lift

Push

Ice Maker

Door Pin

d) Remove the wire shield screw from the

bottom of the ice maker.

Wire Shield Screw

e) From the rear of the ice maker, lift the

top of the wire shield slightly and pull it

back to release it from the ice maker.

f) Press up on the two retaining clips (one

on each side) at the bottom of the ice

maker tracks with a fingernail of each

hand, pull the ice maker forward, and

remove it.

Track

g) If you are completely removing the

ice maker, unplug the wiring harness

connector from the ice maker.

4-2

Wire

Shield

Retaining Clip

(1 on each track)

Harness

Connector