Whirlpool 4378870 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Whirlpool 4378870에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 4378870 11 페이지.

페이지 인쇄

Important

Do not discard dispenser trim or instructions.

Decorator

Door Panel Installation

Instructions

l/4" (6 mm) Panel Dimensions

2. Dispenser

Models

Listed-below

are required height x width dimensions

for

decorator panels. Panels are not supplied with this kit and

can be purchased locally. Refrigerator panels should not

weigh more than 30 pounds and freezer panels should not

weigh more than, 15 pov&

WI It-r

b,iVldZn4

ICI-IL

Refrigerator-Door

Panel

Upper Freezer Door Panel

Lower Freezer Door Panel

General

63 3/32" x 19 310"

i a 3tw

i 3 3149'

31 9/l 6" x 13 3/4"

Remove crushed/cubed

ice switch cover on dispenser

by placing taped edge of putty knife underneath cover

and pulling out. Release bottom clips on dispenser

cover by placing taped edge of putty knife underneath

cover and pulling out. Release top clips by holding

bottom of dispenser cover out and sliding up.

ul (u

WARNING

Electrical Shock Hazard

Disconnect electrical power before installing panels.

Failure to do so can result in death or electrical shock.

Personal Injury Hazard

Wear gloves and protect arms when handling trim

pieces.

injury.

Failure to do so could result in cuts or other serious

3. Remove door handle inserts by placing screwdriver at

top of door handles in area between handle and insert

and pulling forward. Pull edge of inserts forward along

length of handles.

' I

Caution

To avoid property damage, protect soft vinyl or other

flooring with cardboard,

rugs, or other protective

material.

Procedure

Important

Save all screws and reuse in original location.

1. Remove top handle end caps by removing screws.

WARNING

Failure to do so could result in personal injury.

4. Remove door handles by removing screws.

Important

Decorator panels should be cut to "l/4" panel dimensions.

Refer to "l/4" Decorator Panel Dimensions"

section.