Acom AC-100 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Acom AC-100에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acom AC-100 16 페이지. Advanced counting scale

Counting by Using PLUs

1. Make sure the Zero and Stable Lamps are on.

2. Place the parts that you wish to count on the platter.

3. Enter the PLU number of the part that you wish to count. PLU

numbers range from 0 to 199.

4. Make sure that the Stable Lamp is on.

5. Press the !M key.

Steps 2 & 3 can be interchanged. The scale will now display a unit

weight and a count. The scale may also flash the Ls or Lu Lamps

depending on certain criteria specified on page 4. You can begin

counting.

Using the ADD Function

1. Get into counting mode by using any of the 3 ways of counting

(counting by unit weight, sample, or PLU.)

2. Place the batch of parts that you wish to add onto the platter.

3. Make sure that the Stable Lamp is on.

4. Press the ADD key. The displays will show:

5. The Count display above shows 500 as an example.

The number in the Count Display represents the Running Total

Count.

The Number in the Unit Weight display shows the number of

times batches have been added to the Running Total Count.

6. Remove the batch of parts that have just been added.

7. If there is another batch of parts you wish to add go to step 2

otherwise continue on to step 8.

8. Press the SUM key. The displays will show:

Add

totAL

500

5000