Acom JW-1 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Acom JW-1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acom JW-1 16 페이지. Top loading balance
Acom JW-1에 대해서도 마찬가지입니다: 소유자 매뉴얼 (3 페이지)

Simple Weighing

1. Make sure that the balance is at ZERO and STABLE

2. Place a load on the platter

3. After the STABLE indicator turns on you may read the weight

4. Remove the load

Entering Tares

1. Make sure that the balance is at ZERO and STABLE

2. Place the container to be tared on the platter

3. After the STABLE indicator turns on press the TARE key

4. The display should be at zero and the NET, STABLE, and ZERO

lamps should all be on

Removing Tares

1. Make sure that the balance is at ZERO, STABLE, and NET

2. Remove the tared container from the platter

3. The display should be at a negative weight and the NET,

STABLE, and ZERO lamps should all be on

4. Press the TARE key

5. The display should now show zeros and be at ZERO and

STABLE

Simple Weighing Using Tares

1. Make sure that the balance is at ZERO and STABLE

2. Follow directions for entering a tare

3. Place a load on the platter

4. After the STABLE indicator turns on you may read the weight

5. Remove the load

6. You may continue to use the same tare by returning to step 3 in

this procedure, OR continue to step 7

7. Follow steps for Removing Tares

Parts Counting

1. Press the MODE key until you reach Counting mode (pcs)

2. Make sure that the balance is at ZERO and STABLE

3. Press the SET key

4. The display will read SEt 10

5. Place sample of 10 pieces on the platter and press the SET key

6. If the sample is not within the Minimum Piece Weight and

Minimum Sample Weight for the balance's specific capacity, then

the balance will loop back to step 5 but this time asking for a

(continued)