Whirlpool WSC5553 A+N 설치 매뉴얼 - 페이지 3

{카테고리_이름} Whirlpool WSC5553 A+N에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WSC5553 A+N 6 페이지. Eco-friendly side by side american black fridge-freezer, wsc5553 a+n

페이지 인쇄

LEVELLING YOUR REFRIGERATOR

The refrigerator has two front and two rear wheels at the

base of the product on each side that can be adjusted (see

figure A), or four wheels of which only the two front wheels

can be adjusted (see figure B).

If the appliance seems unsteady or you want the doors to

close easier, adjust the appliance's tilt following the

instructions below (depending on the model, as shown in the

figures on the right).

1. Check the installation location to be sure you have at least 1 cm

clearance on all sides including the top.

2. Connect the appliance to the mains power supply.

3. Move the refrigerator into its final position.

4. Open both doors and remove the plinth to locate the levelling bolts

at the left and right of the refrigerator base. The top bolt (1) will

adjust the rear wheel (if provided), and the bottom bolt (2) will

adjust the front wheel.

5. Use the wrench provided to adjust the levelling bolts. Turn the

levelling bolt clockwise to raise the appliance, or anti-clockwise to

lower it.

It may take several turns of the levelling bolts to adjust the tilt of

the refrigerator.

Note: do not unscrew the levelling bolts too much when

lowering the appliance as they could fall out.

Aligning the doors

If, after switching on the appliance and adjusting the refrigerator and

freezer doors, the doors are misaligned, disconnect the appliance

from the power supply and adjust both doors as indicated in the

enclosed diagram.

Figure A

Figure B