Whirlpool WUB50X24EM 사용 및 관리 매뉴얼 - 페이지 9

{카테고리_이름} Whirlpool WUB50X24EM에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WUB50X24EM 36 페이지. Beverage center

페이지 인쇄
Whirlpool WUB50X24EM 사용 및 관리 매뉴얼

Changing the Light Bulb

NOTE: Not all appliance bulbs will fit your beverage center.
Be sure to replace the bulb with one of the same size, shape,
and wattage.
To change the light bulb:
1.
Unplug beverage center or disconnect power.
2.
Using a Phillips screwdriver, remove the screw located at the
back of the light shield. Pull the light shield back to remove
the tabs from the appliance. Remove the light shield.
A
A. Light shield
B. Tabs
C. Screw
3.
Replace the bulb.
4.
Reinstall the light shield by inserting the tabs. Align the holes
and insert the screw. Tighten the screw.
5.
Plug in beverage center or reconnect power.
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Your beverage center will not operate
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Is the power supply cord unplugged? Plug into a grounded
■
3 prong outlet.
If you choose to turn the beverage center off before you leave,
follow these steps.
1.
2.
3.
4.
B
When you are moving your beverage center to a new home,
follow these steps to prepare it for the move.
1.
2.
C
3.
4.
5.
When you get to your new home, put everything back and refer to
the "Installation Instructions" section for preparation instructions.

TROUBLESHOOTING

■
■
■
■

Vacation and Moving Care

Vacations
Remove all wine bottles from the beverage center.
Unplug the beverage center.
Clean the beverage center. See "Cleaning."
Tape a rubber or wood block to the top of the door to
prop it open far enough for air to get in. This stops odor
and mold from building up.
Moving
Remove all wine bottles from the beverage center.
Unplug the beverage center.
Clean, wipe, and dry it thoroughly.
Take out all removable parts, wrap them well, and tape
them together so they don't shift and rattle during the
move.
Tape the doors shut and tape the power cord to the
beverage center.
Has a household fuse blown, or has a circuit breaker
tripped? Replace the fuse or reset the circuit.
Is the Beverage Center Control turned to the OFF
position? See "Using the Control."
The lights do not work
Is a light bulb loose in the socket? Unplug beverage center
or disconnect power. Gently remove the bulb and reinsert.
Plug in beverage center or reconnect power.
Has a light bulb burned out? Replace with an appliance bulb
of the same wattage, size, and shape. See "Changing the
Light Bulb."
9