FIREPITS Arcturus 사용 설명서 - 페이지 10

{카테고리_이름} FIREPITS Arcturus에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. FIREPITS Arcturus 12 페이지.

 Ensure the Burner area is kept clean and clear of dirt and especially anything com-

bustible.

 The lava rocks will show signs of soot, which will not harm the rocks, but could

build up and block the Burner jets. Simply remove the rocks and wash and scrub

with a stiff brush to remove the soot.

 If you haven't used the Firepit for some time, it might attract spiders and other

insects. It's recommended you remove the lava rocks. Clear the burner area of

anything that doesn't belong and then replace the lava rocks.

Pilot fails to light.

 Make sure the main gas supply is turned on. (Check bottle is not empty)

 Try pressing the ignition button several times. Make sure you are keeping the main

gas lever pressed in for at least 10 seconds. It's quite a strong spring.

 If the ignition button stays in, lubricate with WD40 with the burner not lit.

 Keep trying as it can take quite some time to purge all the air from the pipes.

 Move the lava rocks from above the pilot cage, and ensure cage area is clear. Try

relighting.

 Try lighting the pilot with a match or lighter, as the spark electrode might be wet

and inoperative.

Main Burner fails to Light

 If the pilot is lit, there is no reason the main burner would not light.

 If the pilot is not lit, the flame failure device has cut off the gas supply. Wait 2 min-

utes, then try relighting the pilot.

Main Burner suddenly goes out.

 If the pilot is extinguished for any reason, ie a sudden gust of wind, or it started

raining, then the main gas supply is automatically cut. Turn the control lever to the

off position, and leave for 2 minutes before relighting the pilot. Once the pilot is lit,

the main burner will work.

 Your gas bottle is maybe empty. Replace the bottle for a full one.

Maintenance