Clam EDGE 작동 및 부품 설명서 - 페이지 7

{카테고리_이름} Clam EDGE에 대한 작동 및 부품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clam EDGE 8 페이지. Power augers

Maintenance of your Edge auger

Spark plug inspection and replacement

You should inspect your spark plug for proper gap after approximately every 50 hours of use

For optimum performance, the spark plug gap should measure .019"

Replace when electrodes have become badly worn-or approximately every 100 hours of use

1. Remove the spark plug cover-item #12 on page 2, by pressing down on it and

pulling back from the powerhead. You'll need to slightly lift it to fully remove.

2. Once the cover has been removed, you can gently pull off the ignition wire, and

remove the spark plug with a ¾" socket and ratchet.

3. Measure the gap on your spark plug. Adjust or repace as necessary.

4. Reinstall spark plug, ignition wire and spark plug cover.

Note: Replacement spark plugs are offered in several

brands. Champion's RCJ-6Y and Bosch's WSR6F are

two viable options.

Air filter inspection, cleaning and replacement

You should inspect your air filter for cleanliness after approximately every 50 hours of use

Inspect and clean the air filter more frequently if you notice a performance reduction in your auger.

Or, if you notice your auger using more gas than typical.

Set your choke to the "Start" position, which will close the choke

and prevent any contaminants from entering your carburetor.

2. Turn the wing screw (knob of left side of image) counter-

clockwise and pull the air filter cover toward you from the left

side to remove it.

3. Once the cover has been removed, remove air filter by gently

pressing down on the upper part of the filter on the rubber-not

element, itself.

4. To clean, lightly tap on the filter to free contaminants. Do not

use compressed air or clean with water.

5. Reinstall cleaned or new filter. (New filter p/n is 2048154)

6. Reinstall Air Filter cover by installing the guide pins on the right

hand side first, then pushing the left side towards the motor.

Turn wing screw Clockwise to secure.

Never adjust the carburetor to compensate for the air

filter. Replace as necessary or damage could occur.