Whirlpool LER3622PQ 사용 및 관리 매뉴얼 - 페이지 18

{카테고리_이름} Whirlpool LER3622PQ에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool LER3622PQ 20 페이지. Cabrioâ® high efficiency electric dryer with accudryâ„¢ drying system ventilation specification
Whirlpool LER3622PQ에 대해서도 마찬가지입니다: 치수 (1 페이지), 사용 및 관리 매뉴얼 (20 페이지), 사용 설명서 (8 페이지)

페이지 인쇄

1. Starting Your Dryer

■

Is the exhaust vent diameter the correct size?

Use 4" (102 mm) diameter vent material.

■

Is the dryer located in a room with temperature below

45ºF (7ºC)?

Proper operation of dryer cycles requires temperatures above

45ºF (7ºC).

■

Is the dryer located in a closet?

Closet doors must have ventilation openings at the top and

bottom of the door. The front of the dryer requires a minimum

of 1" (25 mm) of airspace, and the rear of the dryer requires a

3" (76 mm). See "Installation Instructions."

■

Has an air dry modifier been selected?

Select the right temperature for the types of garments being

dried. See "Cycles."

■

Is the load too large and heavy to dry quickly?

Separate the load to tumble freely.

Cycle time too short

■

Is the automatic cycle ending early?

The load may not be contacting the sensor strips. Level the

dryer.

Change the dryness level setting on Automatic Cycles.

Increasing or decreasing the dryness level will change the

amount of drying time in a cycle.

Lint on load

■

Is the lint screen clogged?

Lint screen should be cleaned before each load.

Stains on load or drum

■

Was dryer fabric softener properly used?

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can

stain your garments.

Drum stains are caused by dyes in clothing (usually blue

jeans). This will not transfer to other clothing.

Loads are wrinkled

■

Was the load removed from dryer at the end of the cycle?

■

Was the dryer tightly packed?

Dry smaller loads that can tumble freely.

Odors

■

Have you recently been painting, staining, or varnishing in

the area where your dryer is located?

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

■

Is the dryer being used for the first time?

The new electric heating element may have an odor. The odor

will be gone after the first cycle.