Whirlpool WED7500VW 사용 및 관리 매뉴얼 - 페이지 5
{카테고리_이름} Whirlpool WED7500VW에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WED7500VW 20 페이지. Compact electric dryer with 11 cycles
Whirlpool WED7500VW에 대해서도 마찬가지입니다: 사양 (8 페이지), 사용 및 관리 매뉴얼 (20 페이지), 치수 및 설치 정보 (1 페이지), 사용 설명서 (8 페이지), 설치 지침 (2 페이지)
Installation Clearances
The location must be large enough to allow the dryer door to
open fully.
Dryer Dimensions
39"
(99.1 cm)
23 "
(59.37 cm)
*Most installations require a minimum 5½" (14.0 cm) clearance
behind the dryer for the exhaust vent with elbows. See "Venting
Requirements."
Installation spacing for recessed area and closet
installations
The following spacing dimensions shown are recommended
when the dryer is to be operated with, or without, the Stack Kit.
This dryer has been tested for installation with spacing of
0" (0 cm) clearance; however, spacing of 1" (2.5 cm) clearance is
recommended. Recommended spacing should be considered for
the following reasons:
Additional spacing should be considered for ease of
installation and servicing.
Additional spacing should be considered on all sides of the
dryer to reduce noise transfer.
For closet installation with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation opening are
acceptable.
Companion appliance spacing should also be considered.
To purchase a Stack Kit, see "Assistance or Service."
Custom undercounter installation - Dryer only
0"
(0 cm)
33 " min.
(84.45 cm)
0"
(0 cm)
*
23 ¼"
(60.3 cm)
33 ¼"
(84.45 cm)
23 "
0"
(59.37 cm)
(0 cm)
Recessed or closet installation - Dryer only
14"
(35.6 cm)
18"(45.7 cm)
3"
(7.6 cm)
0"
1" (2 . 5 cm)
(0 cm)
A
A. Side view - closet or confined area
B. Recessed area
C. Closet door with vents
Recessed or closet installation - Stacked with stack kit
(Accessory)
12"
(30.5 cm)
DRYER
WASHER
0" (0 cm)
0" (0 cm)
1" (2.5 cm)
A
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
Mobile Home - Additional Location Requirements
This dryer is suitable for mobile home installations. The
installation must conform to the Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home Construction
and Safety, Title 245, HUD Part 280).
Mobile home installations require:
Metal exhaust system hardware, which is available for
purchase from your dealer.
Special provisions must be made in mobile homes to
introduce outside air into the dryer. The opening (such as a
nearby window) should be at least twice as large as the dryer
exhaust opening.
(7.6 cm)
2
48 in.
2
(310 cm
)
2
24 in.
2
(155 cm
)
(7.6 cm)
0"
(0 cm)
B
C
3" (7.6 cm)
(7.6 cm)
2
48 in.
2
(310 cm
)
2
24 in.
2
(155 cm
)
(7.6 cm)
B
C
3"
3"
3"
3"
5