Whirlpool WED97HEXL 사용자 설명서 - 페이지 12

{카테고리_이름} Whirlpool WED97HEXL에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool WED97HEXL 24 페이지. Electronic dryer
Whirlpool WED97HEXL에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 사용 및 관리 매뉴얼 (36 페이지)

페이지 인쇄

connect remaining wires

Place hooked ends of remaining direct wire cable wires under

outer terminal block screws (hooks facing right). Squeeze hooked

ends together and tighten screws. Finally, reinsert tab of terminal

block cover into slot of dryer rear panel. Secure cover with

hold-down screw. Now, go to Venting Requirements.

optional External Ground for

3-Wire connection

(

Power Supply cord Shown)

ImPoRTAnT: You must verify with a qualified electrician that this

grounding method is acceptable before connecting.

Prepare to connect neutral ground

wire and neutral wire

Install the correct strain relief for your electrical connection

method, as shown on page 8 or 10.

Remove center terminal block screw (B). Remove neutral ground

wire (E) from green external ground conductor screw (A).

connect neutral ground wire and

neutral wire

Connect neutral ground wire (E) and neutral wire (white or

center wire) (C) of power supply cord or cable under center,

terminal block screw (B). Tighten screw.

connect remaining wires

Place ends of remaining wires under outer terminal block

screws. Tighten screws.

connect external ground wire

Connect a separate copper ground wire (G) under the green

external ground conductor screw (A) to an adequate ground.

Finally, reinsert tab of terminal block cover into slot of dryer

rear panel. Secure cover with hold-down screw. Now, go to

Venting Requirements.