Whirlpool 29" 설치 지침 매뉴얼 - 페이지 16

{카테고리_이름} Whirlpool 29"에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 29" 48 페이지. Dryer
Whirlpool 29"에 대해서도 마찬가지입니다: 설치 지침 매뉴얼 (22 페이지)

페이지 인쇄

Level Dryer

Level dryer

Check levelness of dryer from side to side. Repeat from

front to back.

NOTE: The dryer must be level for the moisture sensing system

to operate correctly.

Not Level

Tighten and adjust leveling legs

If dryer is not level or the same height as the washer, prop up

using a wood block. Use wrench to adjust legs up or down,

and check again for levelness. Once legs are level, make sure

all four legs are snug against the floor before tightening them.

LEVEL

Not Level

Complete Installation Checklist

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

Check that you have all of your tools.

Dispose of/recycle all packaging materials.

Check dryer's final location. Be sure vent is not crushed

or kinked.

Check that dryer is level. See "Level Dryer."

Remove film on console and any tape remaining on dryer.

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

Read "Dryer Use" in your "Use and Care Guide."

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

Be sure the water faucets are on.

Check for leaks around "Y" connector, faucet, and hoses.

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

If the dryer will not start, check the following:

Dryer is plugged into a grounded 3-prong outlet.

■

Electrical supply is connected.

■

Household fuse is intact and tight, or circuit breaker has

■

not tripped.

Dryer door is closed.

■

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle and

close the door.

If you do not feel heat, turn the dryer off and check to see

whether gas supply line shut-off valve is open.

If the gas supply line shut-off valve is closed, open it,

■

then repeat the 5-minute test as outlined above.

If the gas supply line shut-off valve is open, contact a

■

qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.