Whirlpool 3396304 사용 및 관리 매뉴얼 - 페이지 18

{카테고리_이름} Whirlpool 3396304에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3396304 29 페이지. Electronic gas and electric dryers

페이지 인쇄

Removing

accumulated

lint

Lint can gather inside the dryer and be a fuel

for fire. It is recommended that lint be removed

every 2 to 3

years,

or more often, depending

on dryer usage. Cleaning should be done by a

qualified person. If you have any questions,

please call our Consumer Assistance Center at

1-800-253-l

301.

For all electric dryers, or gas dryers which

have a lower front access panel

Electrlcal Shock and

Personal InJury Hazard

Unplug the power supply cord or turn off

the electrical power before removing

dryer panels.

Make sure the dryer is cool.

Dryer parts can have sharp edges. Use

care when handling.

When replacing front panel after lint

removal, the wire clips holding the door

switch wires must be anchored to top of

front and side panels. Wires MUST NOT

touch rotating drum. (See page 19,

step 7.)

Failure to do so could result in electrical

shock or personal injury.

See page 19 if your dryer is gas and has a full

front panel.

Unplug the power supply cord or turn off the

electrical power.

Thermostats

Heat element

2. Remove back panel (electric) or lower front

access panel (gas). See the Installation

Instructions.

3. Remove lint from shaded area in illustration

with a soft brush or vacuum cleaner. Avoid

damaging wires, thermostats (electric),

funnel (gas) or ignitor (gas).

4. Replace panel; reconnect and level dryer

again, if necessary.

Electric

dryer with back panel removed

lgnitor

Funnel

Gas dryer with front panel removed