Whirlpool 3978906 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Whirlpool 3978906에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3978906 10 페이지. Gas dryer set to operate on natural gas

페이지 인쇄

Dryer location

and dimensions

14-1/2"

42-3/8"*

6"*

9-1/4"

2-1/8"

gas burner inlet

pipe connection

at rear of dryer

28" max.**

*from floor with

dryer feet

extended 1 inch

For proper drying performance:

The location must provide:

Protection from weather and water: Do not

store or use dryer where it will be exposed to

water and weather.

Room temperature above 45°F: If room

temperature is below 45°F, automatic cycles

may not shut off.

It is your responsibility to:

Observe all governing

codes and ordinances.

Check code requirements:

Some codes limit or do not

permit installation of clothes

dryers in garages, closets,

mobile homes or sleeping

quarters. Contact your local

building inspector.

Recessed area/closet installation

Installation clearances.

Use recommended clearance for easier

installation.

Recommended/Minimum

Recessed

Back

Sides

5"/0"

1"/0"

Exhausted

18"/18"

5"/4"

1"/0"

Closet

18"/18"

No other fuel burning appliance may be

installed in the same closet or recessed area.

• If codes permit, dryer may be installed in a

recessed area or closet using dimensions

shown.

• Dimensions are in inches and are the

minimum allowable. Detailed space

requirements can also be found on the label

on the back panel of the dryer. These

requirements ensure minimum clearances to

combustible construction, and prevent

blockage of air into the combustion chamber.

• Additional spacing should be considered for

ease of installation and servicing. Companion

appliance spacing should also be considered.

Door clearance

Location must be large enough to fully open dryer door.

3-7/8"

22-3/4"

19-1/8"

Super-large

side-swing door (reversible)

Panel A

WARNING: For your safety the

information in this manual must

be followed to minimize the

risk of fire or explosion or to

prevent property damage,

personal injury or death.

— Do not store or use gasoline,

— WHAT TO DO IF YOU SMELL

dryer exhaust

vent

• Do not try to light any

29"

**Most installations will

require at least 5-inch

clearance behind the

dryer for the dryer vent.

Level floor: Maximum slope under entire dryer

should not be more than 1 inch. (If slope is

greater than 1 inch, install Extended Dryer Feet

Kit, Part No. 279810.) Clothes may not tumble

properly and automatic sensor cycles may not

operate correctly if dryer is not level.

Comply with the installation

specifications and

dimensions.

Consider spacing

requirements for companion

appliances.

Make sure you have

everything necessary for

proper installation.

Recessed area installation

Top

Front

—

1"/1"

0"***

***

|Wall, door and floor molding may require

additional spacing.

22-3/4"

Large side-swing

door (reversible)

or other flammable vapors and

liquids in the vicinity of this or

any other appliance.

GAS:

appliance.

Keep flammable materials and vapors, such as gasoline, away from dryer.

Place dryer at least 18 inches above the floor for a garage installation.

Failure to do so can result in death, explosion, or fire.

Properly install dryer.

Contact a qualified installer

to insure that the electrical

and gas installations meet all

national and local codes and

ordinances.

Exhaust to outdoors: Dryer

must be exhausted outdoors

to prevent exposure to

harmful substances in the gas

fuels.

front view

18"

0"***

15-1/4"

17-3/4"

22-3/4"

Small side-swing door

• Do not touch any electrical

switch; do not use any phone

in your building.

• Clear the room, building or

area of all occupants.

• Immediately call your gas,

supplier from a neighbor's

phone. Follow the gas

supplier's instructions.

• If you cannot reach your gas

supplier, call the fire

department.

— Installation and service must

be done by a qualified

installer, service agency or

the gas supplier.

WARNING

Explosion Hazard

Sturdy floor to support dryer weight of

175 pounds.

This installation must conform with local

codes, or in the absence of local codes with

the National Fuel Gas Code ANSI

Z223.1/NFPA 54 installation codes*.

Copies of the standards listed may be obtained

from:

*CSA International

8501 East Pleasant Valley Road

Cleveland, Ohio 44131-5575

Closet/confined area installation

If a closet door is installed: The minimum

unobstructed air openings are required.

Louvered doors with equivalent air openings

are acceptable.

front view

48 sq. in.

closet

door

24 sq. in.

Minimum top and bottom air openings for

closet door.

***

External exhaust elbow requires additional

space.

25-5/8"

8-1/4"

15-1/4"

13-3/4"

15-1/4"

Extra-large hamper door

side view

14"

max.

***

8-3/4"

13-3/4"