Whirlpool 3LWED4915 사용 및 관리 매뉴얼 - 페이지 13

{카테고리_이름} Whirlpool 3LWED4915에 대한 사용 및 관리 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Whirlpool 3LWED4915 14 페이지. Electric or gas dryer

페이지 인쇄

Troubleshooting

First try the solutions suggested here to possibly avoid the cost of a service call.

If you experience

Cycle time too short

Lint on load

Stains on load or drum

Loads are wrinkled

Odors

Load is too hot

Latin America Service

For other countries in Latin America, see our Warranty Card Latin America and visit our Whirlpool Latinoamerica website

Possible Causes

Automatic cycle ending early.

Lint screen clogged.

Dryer fabric softener not properly used.

Load not removed from dryer at the end

of the cycle.

Dryer tightly packed.

You have recently been painting, staining,

or varnishing in the area where your dryer

is located.

The electric dryer is being used for the

first time.

Laundry items removed from the dryer

before the end of the cycle.

A high temperature cycle was used,

or a separate temperature control was

set on High.

www.whirlpool-latam.com.

Solution

The load may not be contacting the sensor strips.

Level the dryer.

Use Timed Dry for very small loads. Change the Dry Level

setting on Automatic Dry cycles.

Increasing or decreasing the Dry Level setting will change

the amount of drying time in a cycle.

Lint screen should be cleaned before each load.

Add dryer fabric softener sheets at the beginning of the

cycle. Fabric softener sheets added to a partially dried

load can stain your garments.

Drum stains are caused by dyes in clothing (usually blue

jeans). These will not transfer to other clothing.

Select Wrinkle Shield

feature to tumble the load without

™

heat to avoid wrinkling.

Dry smaller loads that can tumble freely to reduce the

chance of wrinkles forming.

If so, ventilate the area. When the odors or fumes are gone

from the area, rewash and dry the clothing.

The new electric heating element may have an odor.

The odor will be gone after the first cycle.

Allow Cool Down cycle to finish before removing

laundry from dryer. All cycles are cooled slowly to reduce

wrinkling and make it easier to handle. Items removed

before Cool Down may feel very warm.

Select a lower temperature and use an automatic drying

cycle. These cycles sense the temperature or the moisture

level in the load and shut off when the load reaches the

selected dryness. This reduces overdrying.